I seem to recall that M4 gets stuck on footprint names with a - in them. Try TO18 or TO_18.
Stuart On Sun, 17 Aug 2008, Robert Butts wrote: > I think the problem is in the footprints. For to TO-18 I wrote TO-18 and > I'm thinking gsch2pcb is getting stuck there. > > On Sun, Aug 17, 2008 at 6:25 PM, <[EMAIL PROTECTED]> wrote: > >>> I'm trying to run a very simple schematic thru gsch2pcb and it's getting >>> stuck. The printout says: using the m4 processor for pcb footprints >> >> Are you using newlib (file type) or M4 footprints? I rename the directory >> for the M4 stuff and only use newlib footprints that I create. >> >> Does gsch2pcb stop at a point and tell you the results of it's job? >> >>> Aside >>> from that it's just a thru hole definition. Any ideas? >> >> This shouldn't make any difference. >> >> Phil >> >> >> >> _______________________________________________ >> geda-user mailing list >> geda-user@moria.seul.org >> http://www.seul.org/cgi-bin/mailman/listinfo/geda-user >> > _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user