On Sun, 2010-10-17 at 14:50 +0200, Markus Hitter wrote: > Hello all, > > yesterday I tried to replace a number of 2-pin jumpers (footprint > JUMPER2) with solder jumpers.
Of course, this should work fine, it does for me. gsch2pcb removes the old footprints, but for my 2009 snapshot it has not put the new ones, you have to do something like "load element data to buffer" to insert the new ones, and you may have to load the new netlist again. And you have to watch for the orientation of the new footprints, you may have to rotate them 180 degree. And press "O" key to update ratsnest. Did you make your layout with the autorouter? I have done all manually, so I am not sure if the autorouter needs special care when exchanging footprints. For replacing footprints there is a special mode which allows you to replace single footprints -- sorry can not remember currently. _______________________________________________ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user