Glad it worked and happy birthday.
Add that sentence to your startup script.
start J
Edit|Configure|Startup
press open to edit the startup.ijs script and add the required line
Could you please do one more experiment for me before you start living
with the workaround. It would narrow down the area where the problem
occurs and might suggest a better solution. There are two chunks of code
that might be causing the problem on your machine. The 1st is the
general startup of the front end and the 2nd is the load of the profile
scripts. I would like you to start J without the startup scripts and try
your test.
Start a Command Prompt window (DOS) (same as you did to test
jconsole.exe)
...>\j601\j.exe -jprofile
this starts a barebones J without loading the profile
%0 1 2 3
does this work or fail?
You need to terminate this J session with the following sentence:
2!:55[0
Bear in mind some of the comments Oleg made. J has run on many systems
and, other than the variation reported by Bill and known problems with
some dll calls, we dont' see this problem. There is something wrong with
your system in some deep dark corner. You can probably ignore it, but
don't forget it.
If this problem were more widely reported we would dig much deeper into
finding a solution.
----- Original Message -----
From: "Claude Bélanger" <[EMAIL PROTECTED]>
To: "general - J Software" <[email protected]>
Sent: Wednesday, June 21, 2006 1:06 PM
Subject: Re: [Jgeneral] Crash on % 0 1 2 3
Hi,
It is 13:06, and ALL IS FINE UNDER THE SUN.
From what I tested it seems that I must execute that command everytime
I
open J (win). I remember that there is a file where I should put that
command. Could you tell me wich file. I am relearning at 64( today),
nice birthday gift.
Thanks to everyone who contributed.
Claude Bélanger [EMAIL PROTECTED]
----- Original Message -----
From: "Eric Iverson" <[EMAIL PROTECTED]>
To: "General forum" <[email protected]>
Sent: Wednesday, June 21, 2006 11:25 AM
Subject: Re: [Jgeneral] Crash on % 0 1 2 3
A wild guess is that some action is damaging the floating point state.
Some
dll calls damage the state and require a reset in order for the J
Engine to
continue running properly. For this reason the % option was added to
the cd
mechanism. Please do the following test:
start J
run sentence:
'kernel32 CloseHandle % i i' 15!:0 [0
the result is two boxed zeros
now try your troubling sentence:
%0 1 2 3
----------------------------------------------------------------------
For information about J forums see
http://www.jsoftware.com/forums.htm
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
