On Thu, 2005-10-20 at 16:36 +0200, Holly Bostick wrote: > Michael Sullivan schreef: > > On Thu, 2005-10-20 at 06:11 -0700, Mark Knecht wrote: > > > >> Please give me a bit of info: > >> > >> lspci > >> > >> Basically I'm concerned that the hardware you have and the modules > >> you are trying to load aren't matching up. > > > > Here is the kernel help for the snd_hda_intel driver: > > Say Y here to include support for Intel "High Definition > x Audio" (Azalia) motherboard devices. > x > > x To compile this driver as a module, choose M here: the module > x will be called snd-hda-intel. > x > x Symbol: SND_HDA_INTEL [=n] > x Prompt: Intel HD Audio > x Defined at sound/pci/Kconfig:530 > x Depends on: !M68K && SOUND!=n && PCI && SND > x Location: > x -> Device Drivers > x -> Sound > x -> Advanced Linux Sound Architecture > x -> Advanced Linux Sound Architecture (SND [=m]) > x -> PCI devices > x Selects: SND_PCM > > As I see it, there is no further selection needed to get this detected, > but are we certain that this driver (which does not really specify which > revisions/versions of the motherboard chipset resources are in fact > supported) works with this exact device: > > > 0000:00:1b.0 Class 0403: Intel Corporation 82801FB/FBM/FR/FW/FRW > > (ICH6 Family) High Definition Audio Controller (rev 03) > > ? > > Perhaps there is undocumented support not built, I went to Device > Drivers=>I2C support, and found this: > > CONFIG_I2C_I801: > x > x If you say yes to this option, support will be included for the Intel > x 801 family of mainboard I2C interfaces. Specifically, the following > x versions of the chipset are supported: > x 82801AA > x 82801AB > x 82801BA > x 82801CA/CAM > x 82801DB > x 82801EB/ER (ICH5/ICH5R) > x 6300ESB > x ICH6 > x ICH7 > x ESB2 > x > x This driver can also be built as a module. If so, the module > x will be called i2c-i801. > > x > > x Symbol: I2C_I801 [=m] > x Prompt: Intel 82801 (ICH) > x Defined at drivers/i2c/busses/Kconfig:110 > x Depends on: I2C && PCI > x Location: > x -> Device Drivers > x -> I2C support > x -> I2C support (I2C [=y]) > x -> I2C Hardware Bus support > x > x > > It seems quite possible that this advanced board might need I2c support > statically compiled before the various components can properly > communicate with each other and the kernel. > > Hope this helps. > Holly
I recompiled the kernel removing the SMP and adding what you listed above. You didn't say what part of I2C Hardware Bus support I should add, so I checked everything that said Intel on the Hardware Bus support submenu. It still doesn't detect my snd-hda-intel... -- gentoo-user@gentoo.org mailing list
