Pam, You might try holding the number 4 key down while depressing the reset button. Continue holding that 4 key down for about 20 seconds after you release the reset button. Some of us had to do this in order to get the male voice working when we did the up-grade.
Hope that helps. Dianne ----- Original Message ----- From: Pam Quinn To: [email protected] Sent: Tuesday, October 27, 2009 9:10 PM Subject: [GW-Booksense] Help, I lost the male voice! As the subject line says, I lost the Paul reading voice. If I hold down the five key, it stops talking or reading. If I hold it down again, Kate comes back. I tried resetting, and even tried reinstalling the firmware as I would assume this would be a software issue, but no luck. Suggestions please! Pam If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list andyour message is related to GW Micro or the BookSense, then please consider sending your message to [email protected] so the entire list will receive it. If you wish to unsubscribe from this list, send a message to [email protected] and include leave gw-booksense in the body of the message. If you reply to this message it will be delivered to the original sender only. If your reply would benefit others on the list andyour message is related to GW Micro or the BookSense, then please consider sending your message to [email protected] so the entire list will receive it. If you wish to unsubscribe from this list, send a message to [email protected] and include leave gw-booksense in the body of the message.
