Hi, In documentation for randomise, when viewing the 1-p results in FSLView the min/max display range should be set to 0.95/1.0 so that values less than 0.95 (equivalent to p>0.05) are not shown. If these are corrected values (i.e. corrp) then the visible areas correspond to the statistically significant regions.
Is this the same for viewing PALM results in Workbench? All the values seem to be between 0-1, so that makes sense to me... Thanks so much, Jodi The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail. _______________________________________________ HCP-Users mailing list HCP-Users@humanconnectome.org http://lists.humanconnectome.org/mailman/listinfo/hcp-users