Is there a Default table or exit that is/can be set for all batch submits, so it would work without entering the 'PROF MSGID WTPMSG'?
Thanks, Joe -----Original Message----- From: IBM Mainframe Discussion List [mailto:IBM-MAIN@LISTSERV.UA.EDU] On Behalf Of Lizette Koehler Sent: Tuesday, November 18, 2014 6:51 PM To: IBM-MAIN@LISTSERV.UA.EDU Subject: Re: Batch Msgid Profile The PROFILE you are looking for is the TSO PROF command. Anything you use for TSO can turn this on or off. The easiest thing is to just make it part of the job. In the SYSTSIN DD * section, add this //SYSTSIN DD * PROF MSGID WTPMSG FCQUERY .... Hope this helps. Lizette -----Original Message----- >From: "Murawski,Joseph" <jmura...@travelers.com> >Sent: Nov 18, 2014 3:41 PM >To: IBM-MAIN@LISTSERV.UA.EDU >Subject: Batch Msgid Profile > >When I submit a job and do a 'fcquery devn(xxxx)' or any command using >IKJEFT01 it does not show the msgid in the output(sysout). >But when I do the 'Profile MSGID' and then resubmit the job it will >show the msgid in the sysout. >I was wondering were is the default changed to update this for all batch >submits? > >Thanks Joe > > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN ________________________________ This communication, including attachments, is confidential, may be subject to legal privileges, and is intended for the sole use of the addressee. Any use, duplication, disclosure or dissemination of this communication, other than by the addressee, is prohibited. If you have received this communication in error, please notify the sender immediately and delete or destroy this communication and all copies. TRVDiscDefault::1201 ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to lists...@listserv.ua.edu with the message: INFO IBM-MAIN
