Ofcourse LINUX rejects my port 23 connection that was expected, the point was the VSWITCH works. Ping from windows doesn't work, but I can't ping VM either, although my tn3270 works fine. I think the network blocks pings.. I'll try TRACERT Monday.. CP TRACE I/O on z/LINUX will help.
On Fri, Sep 17, 2010 at 6:01 PM, Davis, Larry (National VM/VSE Capability) < larry.dav...@hp.com> wrote: > The reason Linux rejects the telnet from CMS is TELNET on CMS is using > port 23 and Linux is only excepting connections on port 22 for SSH you can > telnet to the linux image on port 22 from CMS using the command > > TELNET host 22 > > See if you get a connection, or at least a message that the client refused > connection. > > > > If you are using a windows machine try to ping and tracert from your PC to > the Linux image send this data to the network guys > > > > Larry Davis** > > > > *From:* The IBM z/VM Operating System [mailto:ib...@listserv.uark.edu] *On > Behalf Of *Tom Huegel > *Sent:* Friday, September 17, 2010 6:33 PM > > *To:* IBMVM@LISTSERV.UARK.EDU > *Subject:* Re: A little OT z/LIINUX > > > > I can ping the CLIENT from CMS, also from CMS I can Telnet to the CLIENT > (it gets rejected by LINUX). > > > > I'm quite sure the VSWITCH isn't a problem.. I guess my question has been > answered.. It's the network guys ... AGAIN. > > > > On Fri, Sep 17, 2010 at 2:35 PM, Davis, Larry (National VM/VSE Capability) > <larry.dav...@hp.com> wrote: > > Make sure the firewall allows port 22 and that the netmask at the switch > allows addresses to the OSA > > > > If you are using a VSWITCH enter the command Q VSWITCH switch name DETAIL > and paste the response here. > > > > Also , if you are using a VSWITCH did you authorize the client (VM user ID) > access to the vswitch. > > > > > > > > > > Larry Davis > > > > *From:* The IBM z/VM Operating System [mailto:ib...@listserv.uark.edu] *On > Behalf Of *Tom Huegel > *Sent:* Friday, September 17, 2010 5:15 PM > *To:* IBMVM@LISTSERV.UARK.EDU > *Subject:* A little OT z/LIINUX > > > > Looking for a little help. > > I'm trying to install a z/LINUX (SUSE 10) and things went along well to > install the starter system and start CLIENT.. but what next? > > These are the last messages I get from the CLIENT. > > > > *** sshd has been started *** > > > *** login using 'ssh -X r...@172.17.51.121' *** > *** run 'yast' to start the installation *** > > > > At this point what do I do? > > > > The 3270 screen won't take any input. > > If I try to PuTTY into the CLIENT I cannot connect. > > Any suggestions? > > Thanks > > Tom > > >