I run a four port model. It's so new (V2), that the manual doesn;t even cover many of the new administrative functions that the system actuall has. The firmware is 1.39.1, Jul 19 2001.
I have - SPI Disabled - Block WAN Request enbled - Multicast Passthrough eabled - IPSec pass through enabled - PPTP pass through enabled - Remote management disabled - Remote upgrade disenabled - MTU disabled Only my firewall is public. Everything internal uses private IP's, but are accessible through forwarding and NAT. --- [EMAIL PROTECTED] wrote: > I run a similar configuration. > > On the advanced tab I have ENABLED: Block WAN Request, Multicast Pass > Through, IPSec Pass Through, and PPTP Pass Through... > > Running firmware 1.39, and the model is a single port: BEFSR11. > > Hope that might help. > > Do you have it on a public network? Ours is internal. > > I have entertained the thought of putting one as a barrier between my > provider and us, however have not gotten there yet. If I understand > you > correctly, your linksys router is simply a barrier between you and > your > carrier? > > J.J. Beatrice, President > Commandline Media, LLC > http://www.commandlinemedia.com/ > 877-306-8777 TF > 310-306-8777 T > 310-306-0887 F > __________________________________________________ Do You Yahoo!? Send your FREE holiday greetings online! http://greetings.yahoo.com Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/imail_forum%40list.ipswitch.com/
