Kevin, What does the status window look like when the probe "goes dead"?
Regards, Janice Losgar Dartware, LLC -----Original Message----- From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of Kevin Wigle Sent: Thursday, August 28, 2008 10:24 PM To: 'InterMapper Discussion' Subject: [IM-Talk] Peculiar Map Probe Problem We use many map probes on many maps as a way to get around. We have an tiered map system which is used like a table of contents. Often, there may be several map probes on higher maps that point to the same map. Up until recently we had no problems. (though sometimes I wish there was a simple "map jump" that didn't change color to reflect the worse case device) Recently, I have a map probe that will not open the map when it is double clicked. Nothing happens. It also doesn't reflect the worse case device color for the target map. If I delete and recreate it I get no improvement. The same probe on another map works just fine. In fact I copied that probe to the affected map. It worked for a few minutes and then went "dead". Is there a limit to how many map probes can point to the same map? Is there a limit to how many map probes can be on one map? (pointing to other maps) There are no "circular" references. Any suggestions on what could be affecting this probe? ____________________________________________________________________ List archives: http://www.mail-archive.com/intermapper-talk%40list.dartware.com/ To unsubscribe: send email to: [EMAIL PROTECTED] ____________________________________________________________________ List archives: http://www.mail-archive.com/intermapper-talk%40list.dartware.com/ To unsubscribe: send email to: [EMAIL PROTECTED]
