> I'd also appreciate it if people with a pvr150/500 and a pvr250/350 in > NTSC country can do a similar comparison and post the result. All I > need to know is whether there are major saturation differences and the > tveeprom messages in the kernel log of the pvr150/500. > I have not compared the difference in the recordings but there is something strange for me. The Brightness on the 500 seem to go way higher than the brightness of the 350
# ivtvctl -Y -d /dev/video0 (PVR-350) ioctl: VIDIOC_QUERYCTRL Brightness = 127 Contrast = 63 Saturation = 63 Hue = 0 Volume = 52400 Mute = 0 # ivtvctl -Y -d /dev/video1 (PVR-500) ioctl: VIDIOC_QUERYCTRL Brightness = 383 Contrast = 63 Saturation = 63 Hue = 0 Volume = 52224 Mute = 0 This is on 32-bit FC4 with 0.4.3 atrpms ivtv build. Note that 383-256 is exactly 127 and this is what I had it set with. Right after I set it, if I read it, it is the correct value but after a short while (4-5 seconds) it jumps to 383... Does anyone else see this? Dejan PS: These are the ivtv boot messages: ivtv: ==================== START INIT IVTV ==================== ivtv: version 0.4.3 (tagged release) loading ivtv: Linux version: 2.6.15-1.1831_FC4 686 REGPARM 4KSTACKS gcc-4.0 ivtv: In case of problems please include the debug info between ivtv: the START INIT IVTV and END INIT IVTV lines, along with ivtv: any module options, when mailing the ivtv-users mailinglist. ivtv0: Autodetected WinTV PVR 350 card (cx23415 based) ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 5 PCI: setting IRQ 5 as level-triggered ACPI: PCI Interrupt 0000:03:11.0[A] -> Link [LNKC] -> GSI 5 (level, low) -> IRQ 5 tveeprom: The eeprom says no radio is present, but the tuner type 68 tveeprom: indicates otherwise. I will assume that radio is present. tveeprom: ivtv version tveeprom: Hauppauge: model = 48132, rev = K268, serial# = 8207393 tveeprom: tuner = LG TAPE H001F MK3 (idx = 68, type = 47) tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) tveeprom: audio processor = MSP4448 (type = 1b) tveeprom: decoder processor = SAA7115 (type = 13) ivtv0: i2c attach to card #0 ok [client=tveeprom, addr=50] tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #0 ivtv0: i2c attach to card #0 ok [client=(tuner unset), addr=61] saa7115 0-0021: saa7115 found @ 0x42 (ivtv i2c driver #0) ivtv0: i2c attach to card #0 ok [client=saa7115, addr=21] saa7127 0-0044: saa7129 found @ 0x88 (ivtv i2c driver #0) ivtv0: i2c attach to card #0 ok [client=saa7127, addr=44] msp3400 0-0040: chip=MSP4448G-A2 +nicam +simple +simpler +radio mode=simpler ivtv0: i2c attach to card #0 ok [client=MSP4448G-A2, addr=40] msp3400 0-0040: msp34xxg daemon started tda9887 0-0043: (ivtv) chip found @ 0x86 (ivtv i2c driver #0) ivtv0: i2c attach to card #0 ok [client=tda9887, addr=43] ivtv0: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv0: loaded v4l-cx2341x-dec.fw firmware (262144 bytes) ivtv0: Encoder revision: 0x02040011 ivtv0: Decoder revision: 0x02020023 ivtv0: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv0: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv0: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv0: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) ivtv0: Create encoder radio stream ivtv0: Allocate DMA decoder MPEG stream: 16 x 65536 buffers (1024KB total) ivtv0: Allocate DMA decoder VBI stream: 512 x 2048 buffers (1024KB total) ivtv0: Create decoder VOUT stream ivtv0: Allocate DMA decoder YUV stream: 24 x 43200 buffers (1024KB total) ivtv0: loaded v4l-cx2341x-init.mpg firmware (155648 bytes) tuner: type set to 47 (LG NTSC (TAPE series)) by ivtv i2c driver #0 ivtv0: Initialized WinTV PVR 350, card #0 ivtv: ====================== NEXT CARD ====================== ivtv1: Autodetected WinTV PVR 150 card (cx23416 based) ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 11 PCI: setting IRQ 11 as level-triggered ACPI: PCI Interrupt 0000:04:08.0[A] -> Link [LNKB] -> GSI 11 (level, low) -> IRQ 11 tveeprom: Second (radio) tuner idx 101 tveeprom: ivtv version tveeprom: Hauppauge: model = 23552, rev = D492, serial# = 8727875 tveeprom: tuner = Philips FQ1236A MK4 (idx = 92, type = 57) tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) tveeprom: audio processor = CX25843 (type = 25) tveeprom: decoder processor = CX25843 (type = 1e) ivtv1: i2c attach to card #1 ok [client=tveeprom, addr=50] tuner (ivtv): chip found at addr 0xc0 i2c-bus ivtv i2c driver #1 TEA5767 detected. ivtv1: i2c attach to card #1 ok [client=(tuner unset), addr=60] tuner: type set to 62 (Philips TEA5767HN FM Radio) by autodetect type set to 62 (Philips TEA5767HN FM Radio) tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #1 ivtv1: i2c attach to card #1 ok [client=(tuner unset), addr=61] tda9887 1-0043: (ivtv) chip found @ 0x86 (ivtv i2c driver #1) ivtv1: i2c attach to card #1 ok [client=tda9887, addr=43] ivtv1: This is the first unit of a PVR500 cx25840 1-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #1) cx25840 1-0044: loaded v4l-cx25840.fw firmware (14264 bytes) ivtv1: i2c attach to card #1 ok [client=cx25840, addr=44] wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #1) ivtv1: i2c attach to card #1 ok [client=wm8775, addr=1b] ivtv1: Detected a TEA5767 radio tuner. Enabling radio support. ivtv1: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv1: Encoder revision: 0x02040011 ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv1: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv1: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv1: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) ivtv1: Create encoder radio stream tuner: type set to 57 (Philips FQ1236A MK4) by ivtv i2c driver #1 ivtv1: Initialized WinTV PVR 500 (unit #1), card #1 ivtv: ====================== NEXT CARD ====================== ivtv2: Autodetected WinTV PVR 150 card (cx23416 based) ACPI: PCI Interrupt 0000:04:09.0[A] -> Link [LNKC] -> GSI 5 (level, low) -> IRQ 5 tveeprom: Second (radio) tuner idx 101 tveeprom: ivtv version tveeprom: Hauppauge: model = 23552, rev = D492, serial# = 8727875 tveeprom: tuner = Philips FQ1236A MK4 (idx = 92, type = 57) tveeprom: tuner fmt = NTSC(M) (eeprom = 0x08, v4l2 = 0x00001000) tveeprom: audio processor = CX25843 (type = 25) tveeprom: decoder processor = CX25843 (type = 1e) ivtv2: i2c attach to card #2 ok [client=tveeprom, addr=50] tuner (ivtv): chip found at addr 0xc2 i2c-bus ivtv i2c driver #2 ivtv2: i2c attach to card #2 ok [client=(tuner unset), addr=61] tda9887 2-0043: (ivtv) chip found @ 0x86 (ivtv i2c driver #2) ivtv2: i2c attach to card #2 ok [client=tda9887, addr=43] cx25840 2-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #2) cx25840 2-0044: loaded v4l-cx25840.fw firmware (14264 bytes) ivtv2: i2c attach to card #2 ok [client=cx25840, addr=44] wm8775 2-001b: chip found @ 0x36 (ivtv i2c driver #2) ivtv2: i2c attach to card #2 ok [client=wm8775, addr=1b] ivtv2: This is the second unit of a PVR500 ivtv2: Correcting tveeprom data: no radio present on second unit ivtv2: loaded v4l-cx2341x-enc.fw firmware (262144 bytes) ivtv2: Encoder revision: 0x02040011 ivtv2: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total) ivtv2: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total) ivtv2: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total) ivtv2: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total) tuner: type set to 57 (Philips FQ1236A MK4) by ivtv i2c driver #2 ivtv2: Initialized WinTV PVR 500 (unit #2), card #2 ivtv: ==================== END INIT IVTV ==================== ivtv0-osd: Framebuffer module loaded (attached to ivtv card id 0) ivtv0-osd: screen coords: [0 0] -> [720 480] ivtv0-osd: original global alpha = 208 ivtv0-osd: current OSD state = 39 ivtv0-osd: new global alpha = 208 (1 255 0) ivtv0-osd: framebuffer at 0xd5510000, mapped to 0xdd790000, size 1665k ivtv0-osd: mode is 720x480x32, linelength=2880 ivtv0-osd warning: ivtvfb_set_par Console: switching to colour frame buffer device 90x30 ivtv0-osd: fb0: cx23415 TV out frame buffer device ivtv0: Allocate DMA decoder OSD stream: 16 x 65536 buffers (1024KB total) lirc_dev: IR Remote Control driver registered, at major 61 lirc_i2c: chip found @ 0x18 (Hauppauge IR) ivtv0: i2c attach to card #0 ok [client=Hauppauge IR, addr=18] lirc_dev: lirc_register_plugin: sample_rate: 10 ivtv0-osd warning: ivtvfb_check_var ivtv0-osd warning: ivtvfb_set_par ivtv0-osd warning: ivtvfb_check_var ivtv0-osd warning: ivtvfb_set_par ivtv0-osd warning: ivtvfb_check_var ivtv0-osd warning: ivtvfb_check_var ivtv0-osd warning: ivtvfb_set_par _______________________________________________ ivtv-devel mailing list [email protected] http://ivtvdriver.org/mailman/listinfo/ivtv-devel
