Amos, normally all ccc are vlan id / dlci 512-1023. You might want to try 'extended-frame-relay-ccc' and it should take all of those as CCC - but you will then not be able to use any of the DLCIs for, say, IP or so. All CCC or 512-1023. I hope that helps a bit already.
Alexander On Mon, 6 August 2007 18:11:58 +0300, Amos Rosenboim wrote: > Hello All, > > We are trying to migrate a frame relay network onto our mpls network, > based on juniper M10i routers. > We are using frame-relay-ccc encapsulation and l2circuit configuration. > The problem is that we are unable to configure dlci values below 512. > We get the following error when trying to configure units with dlci > below 512: > > CCC or TCC on this interface must have a DLCI >= 512 > > Is this a known limitation? > Can this be worked around somehow? > > This forces us to change dlci values at customers routers, which > makes the migration problematic. > Maybe the choice of ccc encapsulation is wrong, we have chose it just > because it is the first configuration we encountered. > > Any advice would be welcomed. > > > Regards > > Amos _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp