Do you need a device count on configured on the EX like on M/T? For example:
set chassis aggregated-devices ethernet device-count 2 On Fri, Feb 12, 2010 at 6:11 PM, Paul Stewart <p...@paulstewart.org> wrote: > > Hey folks. > > > > I'm cross posting this so apologies if you are both lists. > > > > Trying to get a LAG group up between a Juniper EX4200 switch and a Cisco > 7606 using a pair of GigE's - rush job etc.. can't get the group to come up > and missing something obvious ;) > > > > Cisco: > > > > interface GigabitEthernet3/25 > > description ---------- > > switchport > > switchport access vlan 56 > > switchport mode access > > no cdp enable > > channel-protocol lacp > > channel-group 2 mode active > > > > interface GigabitEthernet3/37 > > description -------------- > > switchport > > switchport access vlan 56 > > switchport mode access > > no cdp enable > > channel-protocol lacp > > channel-group 2 mode active > > > > interface Port-channel2 > > description -------------- > > switchport > > switchport access vlan 56 > > switchport mode access > > end > > > > > > Juniper Side: > > > > ge-0/0/35 { > > description xxxxx-1; > > ether-options { > > 802.3ad ae0; > > } > > > > > > ge-0/0/47 { > > description xxxxxx-2; > > ether-options { > > 802.3ad ae0; > > } > > > > > > ae0 { > > aggregated-ether-options { > > minimum-links 1; > > link-speed 1g; > > lacp { > > passive; > > } > > } > > unit 0 { > > family ethernet-switching { > > port-mode access; > > vlan { > > members xxxxxx; > > } > > } > > } > > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp -- Phill Jolliffe _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp