My bad, missed this change. I added this to the ls-3/0/0:0 interface
mlfr-uni-nni-bundle-options { lmi-type ansi; } Thanks again! > First off, sorry for such a long email. But I figured I would give as much > information as possible upfront to try and give a clear picture about what I > have and what I am currently running. > > Central Office Equipment: > Juniper M20 running v7.5R1.12 > 1x Link Services module (ls-3/0/0) > > Customer Equipment: > Cisco 2611 running c2600-ipbase-mz.124-23 > 2x Eth (e0/0, e0/1) > 4x T1 wic (s0/0, s0/1, s1/0, s1/1) > > The following is the important parts of the config of the Cisco router > > interface MFR0 > description my interface > no ip address > frame-relay lmi-type ansi > frame-relay intf-type dce > > interface MFR0.16 point-to-point > ip address 66.39.177.130 255.255.255.252 > no cdp enable > frame-relay interface-dlci 16 IETF > > interface MFR1 > description Loop2 > no ip address > load-interval 30 > frame-relay lmi-type ansi > > interface MFR1.16 point-to-point > ip address 66.39.177.126 255.255.255.252 > no cdp enable > frame-relay interface-dlci 16 IETF > > interface Ethernet0/0 > ip address 66.39.177.133 255.255.255.252 > half-duplex > > interface Serial0/0 > no ip address > encapsulation frame-relay MFR0 > no arp frame-relay > > interface Serial0/1 > no ip address > encapsulation frame-relay MFR1 > no arp frame-relay > > If I place a cross over cable connecting S0/0 and S0/1, all the links come up. > So I am pretty sure that I have it all configured correctly. I think the > problem is with my Juniper setup, hence the reason I am posting this here. > > > > > Here is my Juniper config: > >> show configuration chassis fpc 3 pic 0 > mlfr-uni-nni-bundles 32; > >> show configuration interfaces t1-1/1/0:0 > description "Bendtel Test leg #1"; > encapsulation multilink-frame-relay-uni-nni; > lmi { > lmi-type ansi; > } > unit 0 { > family mlfr-uni-nni { > bundle ls-3/0/0:0; > } > } > >> show configuration interfaces t1-1/0/0:19 > description "Bendtel Test leg #2"; > encapsulation multilink-frame-relay-uni-nni; > lmi { > lmi-type ansi; > } > unit 0 { > family mlfr-uni-nni { > bundle ls-3/0/0:0; > } > } > >> show configuration interfaces ls-3/0/0:0 > dce; > encapsulation multilink-frame-relay-uni-nni; > unit 16 { > dlci 16; > family inet { > address 66.39.177.129/30; > } > } > unit 17 { > dlci 17; > family inet { > address 10.100.100.1/30; > } > } > > Here is the current status of all these interfaces > >> show interfaces ls-3/0/0:0 > Physical interface: ls-3/0/0:0, Enabled, Physical link is Down > Interface index: 349, SNMP ifIndex: 953 > Link-level type: Multilink-FR-UNI-NNI, MTU: 1508 > Device flags : Present Running > Interface flags: Hardware-Down Link-Layer-Down Point-To-Point SNMP-Traps > Last flapped : 2010-08-13 19:39:56 GMT (6d 20:20 ago) > Multilink Frame Relay UNI NNI bundle options: > Device type DCE > MRRU 1508 > Fragmentation threshold 0 > Red differential delay limit 10 > Yellow differential delay limit 6 > Red differential delay action Remove link > Reassembly drop timer 0 > Links needed to sustain bundle 1 > LIP Hello timer 10 > Acknowledgement timer 4 > Acknowledgement retries 2 > Bundle class A > LMI type ANSI > T391 LIV polling timer 10 > T392 polling verification timer 15 > N391 full status polling count 6 > N392 error threshold 3 > N393 monitored event count 4 > Input rate : 0 bps (0 pps) > Output rate : 0 bps (0 pps) > Multilink Frame Relay UNI NNI bundle statistics: > Frames fps Bytes bps > > Fragments: > Input : 0 0 0 0 > Output: 0 0 0 0 > Packets: > Input : 0 0 0 0 > Output: 0 0 0 0 > Multilink Frame Relay UNI NNI bundle links information: > Active bundle links 0 > Removed bundle links 2 > Disabled bundle links 0 > Multilink Frame Relay UNI NNI active bundle links statistics: > Frames fps Bytes bps > t1-1/0/0:19.0 <-- down > Input : 0 0 0 0 > Output: 0 0 0 0 > Current differential delay 0.0 ms > Recent high differential delay 0.0 ms > Times over red diff delay 0 > Times over yellow diff delay 0 > LIP:add_lnk lnk_ack lnk_rej hello hel_ack lnk_rem rem_ack > Rcv: 0 0 0 0 0 0 0 > Xmt: 15 0 0 0 0 0 0 > t1-1/1/0:0.0 <-- down > Input : 0 0 0 0 > Output: 0 0 0 0 > Current differential delay 0.0 ms > Recent high differential delay 0.0 ms > Times over red diff delay 0 > Times over yellow diff delay 0 > LIP:add_lnk lnk_ack lnk_rej hello hel_ack lnk_rem rem_ack > Rcv: 0 0 0 0 0 0 0 > Xmt: 197 0 0 0 0 0 0 > > Logical interface ls-3/0/0:0.16 (Index 230) (SNMP ifIndex 954) > Flags: Device-Down Point-To-Point SNMP-Traps Encapsulation: > Multilink-FR-UNI-NNI > Statistics Frames fps Bytes bps > Bundle: > Fragments: > Input : 0 0 0 0 > Output: 0 0 0 0 > Packets: > Input : 0 0 0 0 > Output: 0 0 0 0 > Protocol inet, MTU: 1500 > Flags: None > Addresses, Flags: Dest-route-down Is-Preferred Is-Primary > Destination: 66.39.177.128/30, Local: 66.39.177.129 > > Logical interface ls-3/0/0:0.17 (Index 305) (SNMP ifIndex 955) > Flags: Device-Down Point-To-Point SNMP-Traps Encapsulation: > Multilink-FR-UNI-NNI > Bandwidth: 625152kbps > Statistics Frames fps Bytes bps > Bundle: > Fragments: > Input : 0 0 0 0 > Output: 0 0 0 0 > Packets: > Input : 0 0 0 0 > Output: 0 0 0 0 > Protocol inet, MTU: 1500 > Flags: None > Addresses, Flags: Dest-route-down Is-Preferred Is-Primary > Destination: 10.100.100.0/30, Local: 10.100.100.1 > > >> show interfaces t1-1/1/0:0 > Physical interface: t1-1/1/0:0, Enabled, Physical link is Up > Interface index: 444, SNMP ifIndex: 310 > Description: Bendtel Test leg #1 > Link-level type: Multilink-FR-UNI-NNI, MTU: 1518, Clocking: Internal, Speed: > T1, Loopback: None, FCS: 16, Mode: C/Bit parity, > Framing: ESF > Device flags : Present Running > Interface flags: Point-To-Point SNMP-Traps Internal: 0x4000 > Link flags : None > CoS queues : 4 supported, 4 in use > Last flapped : 2010-08-19 18:42:37 GMT (21:24:58 ago) > Input rate : 0 bps (0 pps) > Output rate : 0 bps (0 pps) > DS1 alarms : None > DS3 alarms : None > DS1 defects : None > DS3 defects : None > > Logical interface t1-1/1/0:0.0 (Index 214) (SNMP ifIndex 429) > Flags: Hardware-Down Point-To-Point SNMP-Traps Encapsulation: > Multilink-FR-UNI-NNI > Protocol mfr, Multilink bundle: ls-3/0/0:0, MTU: 0 > Flags: None > >> show interfaces t1-1/0/0:19 > Physical interface: t1-1/0/0:19, Enabled, Physical link is Up > Interface index: 501, SNMP ifIndex: 211 > Description: Bendtel Test leg #2 > Link-level type: Multilink-FR-UNI-NNI, MTU: 1518, Clocking: Internal, Speed: > T1, Loopback: None, FCS: 16, Mode: C/Bit parity, > Framing: ESF > Device flags : Present Running > Interface flags: Point-To-Point SNMP-Traps Internal: 0x4000 > Link flags : None > CoS queues : 4 supported, 4 in use > Last flapped : 2010-07-09 18:35:02 GMT (5w6d 21:32 ago) > Input rate : 0 bps (0 pps) > Output rate : 24 bps (0 pps) > DS1 alarms : None > DS3 alarms : None > DS1 defects : None > DS3 defects : None > > Logical interface t1-1/0/0:19.0 (Index 91) (SNMP ifIndex 625) > Flags: Hardware-Down Point-To-Point SNMP-Traps Encapsulation: > Multilink-FR-UNI-NNI > Protocol mfr, Multilink bundle: ls-3/0/0:0, MTU: 0 > Flags: None > > > Here is the show chassis > > j...@b1-bend-re0> show chassis hardware > Hardware inventory: > Item Version Part number Serial number Description > Chassis 20934 M20 > ... > FPC 3 REV 01 710-001292 AE7635 FPC > PIC 0 REV 01 750-007924 HM0123 1x Link Service(32) > ... > > > For both t1s you can see that they show connected, but for some reason (that > escapes me) the ls interface shows "Hardware-Down" Does this mean the Link > services module is not turned up? To me it isn't clear. > > Any help would be great! > > Thanks > > -- > Jim Lucas > > > -- Jim Lucas _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp