--- Begin Message ---
If link is up, not L1 (speed negotiation) issue. What do you get for output of
show interface xe-0/1/4 extensive?
Richard McGovern
Sr Sales Engineer, Juniper Networks
978-618-3342
I’d rather be lucky than good, as I know I am not good
I don’t make the news, I just report it
On 10/9/20, 10:25 AM, "Łukasz Trąbiński" <luk...@trabinski.net> wrote:
I tried to play with almost all options in gigether-options section without
any results. Port is UP but it still not working properly.
admin@mx1> show configuration interfaces xe-0/1/4
description TEST;
gigether-options {
no-flow-control;
no-auto-negotiation;
speed 1g;
}
unit 0 {
family inet {
address xx.xx.xx.xx/30;
}
}
When i removed "speed 10g" from chassis section and bounced FPC port was
DOWN.
> Wiadomość napisana przez Tobias Heister <li...@tobias-heister.de> w dniu
09.10.2020, o godz. 14:44:
>
> Hi,
>
> Am 09.10.2020 um 13:12 schrieb Łukasz Trąbiński:
>> In Lab I'm trying to set up 1G port on MX204.
>
> You might need to play around with autoneg options. we have a working 1G
LX SFP running on 18.4R1-S7 on MX204
>
> in our case thats the gigether section:
> gigether-options {
> no-flow-control;
> no-auto-negotiation;
> speed 1g;
> }
>
> Not sure if the Flow Control stuff was mandatory, but without the
no-auto-negotation the link was not useable. It might also help to check
autoneg settings on the other end (if you have access).
>
> --
> Kind Regards
> Tobias Heister
Juniper Business Use Only
--- End Message ---
_______________________________________________
juniper-nsp mailing list juniper-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/juniper-nsp
