On Thursday 24 April 2008 20:26:28 sadkra wrote: > Hello Everyone, > > I just finished my first sch-pcb project in Kicad. > > I tried to output the pcb in Postscript format. When I looked > carefully at the Postscript file, I found that some of the pads are > missing &/or some pads are only half drawn in bottom-copper layer > while bottom-copper mask shows the complete pad-mask. > > I may add that gerber output of the same pcb is fine without any > problems. > > It will be of great help if someone throws any light on this. > > regards, > sam_des
The postscript output is NOT for PCB making!!! If you need Postscript for PCB making, use a Gerber Viewer and make a Postscript output from it. You can't "trust" anything but the Gerber file. //Dan, M0DFI