"I've been reading articles about selecting and testing wood. Lots of good 
info. 
Besides Sitka Spruce, Port Orford Cedar, Alaskan Yellow Cedar and Hemlock are 
rated as good choices for airplanes."

I am using Douglas Fir for the longerons and spars on my KR2SS, with one piece 
wing. The Fir is about 16% heaver but 15% stronger in tension and compression 
the spruce. 
I used to grade lumber many, many years ago. So I looked up the specs and 
inspect the lumber myself.
Aircraft grade Douglas Fir is not cheap (look at lumber intended for boat masts 
and cabinet supplies). It is, however a LOT 
cheaper than aircraft grade Spruce!
Pictures of the project are at 
http://picasaweb.google.com/103552664644911775549/KR2SS# . In picture 17 you 
will see the laminations of Fir for the longerons. Look carefully at the 
grain. Grain that fine is not cheap! BTW, it rook an extra 10 hours to build 
the forms so I could build the sides with the "bends" already in them.
I thought that was faster than repairing broken longerons while trying to bend 
the sides into "submission". A large consideration was in making the inside 
seating area
42+ inches wide at the shoulders. That is a lot of bending of the sides if you 
build them flat!

Bob Johnson
Willamina, OR 97396
971-645-9491

Reply via email to