Matthew Schalit wrote:
> Ok the timeout only happends during the first setup, and after that
> goes away. That's was my problem. The first time through, I had no idea
> that setup was going to run, and it sounded very important. However,
> due to the relatively short timeout, I never got a chance to run
> setup and was left at a login prompt. I suggest a 30 sec timeout so
> that a new user has time to read that far and decide.
Maybe I'll just take it out. After all, no one should be skipping that
anyway.
> > > I'll give ya 10 bucks to tell me some more kernel tricks :)
> >
> > Heh heh.
>
> I was serious :)
There may have been an error message when you loaded (about sysreq)....
if not, then you have lots of OTHER fun kernel tricks :-)
> When I log in I see the motd. The last part of the motd is this:
Careful... that's not the motd; that's the usage from acfg and a
message from root's profile.
> > Use one of them as your second disk to use the menu based
> > configuration utility, or load the two packages dialog.lrp
> > and libm.lrp.
> >
> > usage: acfg -e <pkg> ....
> > acfg -a ....
> > acfg -h ....
> > acfg -i ....
> > acfg -l .......
>
> If you simply add "using apkg" as in:
>
> Use one of them as your second disk to use the menu based
> configuration utility, or load the two packages dialog.lrp
> and libm.lrp using apkg.
Good idea.
> Then the new user would be faced with both crucial commands
> right there. I sort of wonder if I'm the only one who got
> a little confused.
Doubt it - you're just the only one who mentioned it. I figure there's
probably a dozen or so who have the same problem but never said
anything.
> Is there an Oxygen mailing list somewhere?
Probably not enough demand for one; the LRP list is the best place to
go.........
_______________________________________________
Leaf-devel mailing list
[EMAIL PROTECTED]
http://lists.sourceforge.net/lists/listinfo/leaf-devel
