Mike Noyes wrote: > > At 2002-02-07 14:12 -0800, Matt Schalit wrote: > >Stefaan Van Dooren wrote: > > > The three pin jumper is for master slave settings for IDE(at least > > > on the my modules it is). > > > > > > I don't see anything about writeprotect on the module. > > > > > > I will check the manuals asap. > > > >Perhaps you have different modules. The one refered to in > >the pdf file clearly shows a jumper on the module in Figure > >2-1 on the bottom of page 8: > > Matt, > This is where I got confused too. There is only one on-board jumper and > it's for selecting master/slave not WP#. Note 2 on the bottom of page 7 > mentions the on-board master/slave jumper. Figure 2-1 is apparently an > illustration of WP# implementation. There is no WP# jumper on the ADM.
Now I'm caught up finally :) The jumper's vaporware as Jeff mentioned and this thread isn't the "How do I write protect my IDE hard drive." So why isn't anybody trying to boot of their nic? Matthew _______________________________________________ Leaf-devel mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-devel
