see the devel-list and the message subject Bering USB example and question from February 1, 2003.
I would only guess that you might try 2.4.20 as the mini-HOWTO does. If nothing else, it's along the lines of fixing segfaults; though I realize you said you got all the modules from the same tree. Good luck, matt S Mohan wrote:
I'm using a Nagasaki MS2300LLL box - Openbrick. I'm trying to load up
driver modules for a USB pen drive and am running into problems. Bering
stable 1.0 2.4.18 kernel. Modules taken from same tree.
Insmod usbcore - goes thro' fine.
Insmod usb-uhci - gives an error. Module has loaded and is initialising
forever. Cannot rmmod also.
Error says init_module not supported.
I also tried insmod uhci, insmod usb-ohci and these two give
segmentation faults. Does any one alse have any experience on this that
I can benefit from?
Bye
Mohan
-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf
_______________________________________________
Leaf-hardware mailing list
[EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/leaf-hardware
------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf _______________________________________________ Leaf-hardware mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-hardware
