I'm trying to configure a new router using Bering-uClibc 3.1. I have two nics that use the same driver 3c59x. Typing:
insmod 3c59x loads the module, but only configures eth0. The output from insmod seems to indicate it found two cards though. All the docs I've found seem to say I need to set to module aliases to get the driver to load for both cards. alias eth0 3c59x alias eth1 3x59x The question is where do I put these lines on a leaf router? ...Izzy ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ ------------------------------------------------------------------------ leaf-user mailing list: leaf-user@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/leaf-user Support Request -- http://leaf-project.org/