If I remember corectly My table did not even come with a board on the rotary table, I do remember installing my own board and turning it down myself. I still have an X on the board that I use to find the center
----- Original Message ----- From: Tim Krause <[email protected]> Date: Thursday, June 17, 2010 3:20 Subject: Rotary Table odd question To: [email protected] > Hello All, > > When I bought my rotary table I discovered that the mdf waste > board provided by Legacy was too big for the table. It was > 13.25" in diameter. The diameter made it hard to turn because > the 20 tooth gear on the rotary table ate into the mdf and left > dimples where the teeth were hitting. I ended up turning the > table down to 13.125" and it fits just fine. My question > is this, did anyone else have the same problem? > > -Tim > > > -- > You received this message because you are subscribed to the > Google Groups "Legacy Ornamental Mills" group. > To post to this group, send email to legacy-ornamental- > [email protected] unsubscribe from this group, send > email to [email protected]. > For more options, visit this group at > http://groups.google.com/group/legacy-ornamental-mills?hl=en. > > -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en.
