well my table is for the revo which I add too to fit the 900 as well but it
seems to be the same dia gears
my blank is 13 5/8 dia which is 1/8 larger than what I think you said yours was
Bill
----- Original Message -----
From: Tim Krause
To: [email protected]
Sent: Friday, June 18, 2010 3:21 AM
Subject: Re: Rotary Table odd question
What's the diameter of the stock one?
----- Original Message -----
From: Bill Bulkeley
To: [email protected]
Sent: Thursday, June 17, 2010 7:22 AM
Subject: Re: Rotary Table odd question
I still have my board unused I made my own and turned it as well so I don't
know if it hits either
Bill
ps Tim what did you think a bout my crazy idea?
----- Original Message -----
From: Tim Krause
To: [email protected]
Sent: Thursday, June 17, 2010 5:26 PM
Subject: Rotary Table odd question
Hello All,
When I bought my rotary table I discovered that the mdf waste board
provided by Legacy was too big for the table. It was 13.25" in diameter. The
diameter made it hard to turn because the 20 tooth gear on the rotary table ate
into the mdf and left dimples where the teeth were hitting. I ended up turning
the table down to 13.125" and it fits just fine. My question is this, did
anyone else have the same problem?
-Tim
--
You received this message because you are subscribed to the Google Groups
"Legacy Ornamental Mills" group.
To post to this group, send email to
[email protected].
To unsubscribe from this group, send email to
[email protected].
For more options, visit this group at
http://groups.google.com/group/legacy-ornamental-mills?hl=en.
--
You received this message because you are subscribed to the Google Groups
"Legacy Ornamental Mills" group.
To post to this group, send email to
[email protected].
To unsubscribe from this group, send email to
[email protected].
For more options, visit this group at
http://groups.google.com/group/legacy-ornamental-mills?hl=en.
--
You received this message because you are subscribed to the Google Groups
"Legacy Ornamental Mills" group.
To post to this group, send email to [email protected].
To unsubscribe from this group, send email to
[email protected].
For more options, visit this group at
http://groups.google.com/group/legacy-ornamental-mills?hl=en.
--
You received this message because you are subscribed to the Google Groups
"Legacy Ornamental Mills" group.
To post to this group, send email to [email protected].
To unsubscribe from this group, send email to
[email protected].
For more options, visit this group at
http://groups.google.com/group/legacy-ornamental-mills?hl=en.
