I still have my board unused I made my own and turned it as well so I don't know if it hits either Bill ps Tim what did you think a bout my crazy idea? ----- Original Message ----- From: Tim Krause To: [email protected] Sent: Thursday, June 17, 2010 5:26 PM Subject: Rotary Table odd question
Hello All, When I bought my rotary table I discovered that the mdf waste board provided by Legacy was too big for the table. It was 13.25" in diameter. The diameter made it hard to turn because the 20 tooth gear on the rotary table ate into the mdf and left dimples where the teeth were hitting. I ended up turning the table down to 13.125" and it fits just fine. My question is this, did anyone else have the same problem? -Tim -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en.
