What do you mean by "Assemble" and "Mounting bolts not where they are suppose to be"? The only assembly I had to do was install four screws in the mdf waste board. Has this changed?
-Tim ----- Original Message ----- From: "pastorcarl" <carstenstig...@verizon.net> To: "Legacy Ornamental Mills" <legacy-ornamental-mills@googlegroups.com> Sent: Thursday, July 22, 2010 7:00 AM Subject: Rotary Table > Greetings all, Well my rotary table arrived Tuesday afternoon. I > have to admit that I was happy to receive it. Took it out of the box > and assembled it. I have it mounted to the rails of my 900 and started > to get the alignment done on it. I have found only a few minor issues > with it so far. Mounting bolts not where they were to be, and loose > hardware. Went over it and got it all fixed up and the center > located. Later on today I will start on playing, er, familiarizing > myself with the capabilities of the table. I have some ideas for a > lamp base or two to get started on and I have a juried show in just a > few weeks to get prepared for. I am working on a hall table with rope > twist legs, a simple skirt and will be making a top of ambrosia maple. > Leaning very heavily to a bowfront frame with a mounted lower shelf of > the same ambrosia maple. > > -- > You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. > To post to this group, send email to legacy-ornamental-mi...@googlegroups.com. > To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. > For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en. > -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to legacy-ornamental-mi...@googlegroups.com. To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en.