Curt, The link to the rotary table at HF is below. http://www.harborfreight.com/3-inch-rotary-table-and-clamping-kit-98077.html
Andrew On Apr 6, 1:38 am, "curt george" <curtgeo...@wowway.com> wrote: > Andy > I realy like Harbor Fright. > I've not seen the turn table, can you post a link to it? > Just curious? > Good luck on this project. > Please let us know how it "turns out". ;-) > > C.A.G. > > > > ----- Original Message ----- > From: "Andy" <atmarti...@gmail.com> > To: "Legacy Ornamental Mills" <legacy-ornamental-mills@googlegroups.com> > Sent: Tuesday, April 05, 2011 11:03 PM > Subject: Re: homemade rotary table > > > The one on HF is 36 turns per rev. I was anticipating on needing to > > make an extension in order to turn it. I was also thinking i would > > mount it on the under side of the rails so the table would be slightly > > above the top of the rails.what is the turns per rev on the legacy > > rotary table? > > > If i were to make my own, i was thinking of using Steven Garrison's > > method for cutting a convolute gear about 10 or 12 inches in diameter. > > Then using the mill to make a worm gear. I have a few large blocks of > > plastic i was planning on using for the gears. I think it would be a > > fun project but im worried about the hysteresis. Perhaps the HF option > > is a more viable option? > > > andrew > > > -- > > You received this message because you are subscribed to the Google Groups > > "Legacy Ornamental Mills" group. > > To post to this group, send email to > > legacy-ornamental-mills@googlegroups.com. > > To unsubscribe from this group, send email to > > legacy-ornamental-mills+unsubscr...@googlegroups.com. > > For more options, visit this group at > >http://groups.google.com/group/legacy-ornamental-mills?hl=en.- Hide quoted > >text - > > - Show quoted text - -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en.