One last plan. I've attached a pdf that shows the exact dimensions to cut your staves to. It will create an 8" column.
-Tim ----- Original Message ----- From: Tim Krause To: legacy-ornamental-mills@googlegroups.com Sent: Thursday, May 17, 2012 6:35 PM Subject: Re: could someone explain the formula Ok, It's picture time. :-) The version on the left is a correct birdsmouth joint as Mike was describing. Your version cut the 90 degree angle in the wrong face as shown on the right. -Tim ----- Original Message ----- From: James Edgell To: legacy-ornamental-mills@googlegroups.com Sent: Thursday, May 17, 2012 6:15 PM Subject: Re: could someone explain the formula you lost me, if you go look at the magnate site they show a bit that cuts a 45 degree angle and with 8 pieces forms a 8 piece column, so using their formula , with 2 inch thick wood, with a 2 inch cut depth on each side of the cut, i need 3 and three eights width across the board to form an 8 inch diameter column, i did that and that is what i ended up with, only giving a little better than 6 inches in diameter for the diameter for the column once it is turned to round . still not sure what i did wrong? On Thu, May 17, 2012 at 7:50 PM, Tim Krause <artmarb...@comcast.net> wrote: Is it safe to say that you understand now where you went wrong? Your version is a pretty cool variation! -Tim ----- Original Message ----- From: James Edgell To: legacy-ornamental-mills@googlegroups.com Sent: Thursday, May 17, 2012 1:11 PM Subject: Re: could someone explain the formula yea i thought it looked pretty cool also, something for future fantasy projects, hahaha -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. To unsubscribe from this group, send email to legacy-ornamental-mills+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/legacy-ornamental-mills?hl=en.
<<bad_birdsmouth_joint.jpg>>
8inch_column_stave_plan.pdf
Description: Adobe PDF document