Very impressive so far joe boy one thing I didn’t think of you will have a fantastic mill for flat stock work as well
Bill From: legacy-ornamental-mills@googlegroups.com [mailto:legacy-ornamental-mills@googlegroups.com] Sent: Thursday, 29 January 2015 7:45 AM To: legacy-ornamental-mills@googlegroups.com Subject: Re: enlarging turning capacity of a legacy showing some photos of a quick mock up i did to see how things are coming along and to take some measurements...photos show a cross section of what will be the enlarged diameter legacy...the measurement between the bed rails(the middle rails) is 19 3/8", exact...from the cross brace at the bottom to the bottom of the "Y"axis( did not have a long enough piece of rail for the mock up so i ganged up what i had) rail is 19 5/8", exact...from this mock up i determined that i need to lengthen the slot for the bed rail supports about 2", so the tail stock can be at the center point of the 19 3/8"...i'll go a bit more just to be sure...i will also cut a piece of plywood into a 19 3/8" circle and place it inside and see if it is practical to make some gussets to go between the cross braces and the vertical supports for some added stability...they would be a bolt on piece...might not need them though, i'll wait till the entire machine is assembled and do a check...so far so good, but a lot of work ahead...all comments welcome...joe -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at http://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at http://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout.