Mike I can see it now, thanks for your time and effort, as you know I have a Woodchuck and am just getting to grips with it It was a bit rusty and several things wrong , like, wires adrift in the switch boxes, and limit switches not lining up. The rusty Leadscrew took a long time on the wire wheel of the grinder, I now have to get a new half-nut as it is well worn. My metal work lathe only goes down to 8TPI Pitty as I could make a new one out of Delrin (is that the right stuff to use ?? ) I don't know if I can do it a 4TPI tap in Delrin I find your Videos very helpful and interesting, thanks a lot. Regards Richard ( In the U.K. with a muddled up government ) Should government have a Capital G ????????
On Friday, July 1, 2016 at 5:18:48 PM UTC+1, LILtwisted wrote: > > Well guys and gals, I decided a few minutes ago to do a quick video about > my Wood Chuck. This will show what I have done and should answer a few > questions and create a lot more. Enjoy https://youtu.be/ooqZZkCp7tI > > Mike > > OK > -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at https://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout.