Confused, that looks like a split nut like a Woodchuck version...
-Tim
On 8/1/2017 5:44 AM, 'joe biunno' via Legacy Ornamental Mills wrote:
here is a photo of the split nut used on the lead screw...a bit odd as
it hinges open and closed...certainly very difficult to replace when
it becomes worn out and most likely I will set up a split block that
was used in later machines...the later type is easier to copy and make
from scratch...trying to avoid getting too involved with this
machine...I do have a use for it and I got it on the cheap, but
finances dictate that I can't do my typical "mod" thing...but since
there are no parts available, (especially for this earlier, 20 year
old machine) I guess I have no choice...thanks...joe
--
You received this message because you are subscribed to the Google
Groups "Legacy Ornamental Mills" group.
To unsubscribe from this group and stop receiving emails from it, send
an email to legacy-ornamental-mills+unsubscr...@googlegroups.com
<mailto:legacy-ornamental-mills+unsubscr...@googlegroups.com>.
To post to this group, send email to
legacy-ornamental-mills@googlegroups.com
<mailto:legacy-ornamental-mills@googlegroups.com>.
Visit this group at
https://groups.google.com/group/legacy-ornamental-mills.
For more options, visit https://groups.google.com/d/optout.
--
You received this message because you are subscribed to the Google Groups "Legacy
Ornamental Mills" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to legacy-ornamental-mills+unsubscr...@googlegroups.com.
To post to this group, send email to legacy-ornamental-mills@googlegroups.com.
Visit this group at https://groups.google.com/group/legacy-ornamental-mills.
For more options, visit https://groups.google.com/d/optout.