The measuring rule originally came from oregonrule.com. I'm not sure if they send their products outside of the USA.
Tim Sent from BlueMail On Sep 6, 2017, 3:46 AM, at 3:46 AM, Richard Ellis <rchrd.ell...@gmail.com> wrote: >I have a Revo, and have been cutting box (finger ) joints using *Mike's > >indexing method,* 3/8" up-cutting two flute spiral milling cutter. I >have >been very surprised at the accuracy of the joints. >One thing I did do was to change the crank handle over -top to bottom- >when >doing the mating piece as I found out to hold it in a vertical >position >was more difficult than holding it down >However I want to do some dovetails* I have no templates* how do I go >about >it?? The pins are easy, it's the mating part. That I am not too sure >about. >Roger, >How many Revo's are in there in the u.k. and can one still get the >stick >on measure tape for the Revo, the long one?? >Richard > >-- >You received this message because you are subscribed to the Google >Groups "Legacy Ornamental Mills" group. >To unsubscribe from this group and stop receiving emails from it, send >an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. >To post to this group, send email to >legacy-ornamental-mills@googlegroups.com. >Visit this group at >https://groups.google.com/group/legacy-ornamental-mills. >For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group. To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com. To post to this group, send email to legacy-ornamental-mills@googlegroups.com. Visit this group at https://groups.google.com/group/legacy-ornamental-mills. For more options, visit https://groups.google.com/d/optout.
