You can add 10 sources to the clipboard. When you open the source clipboard,
it now says "Step 1: Click here to select or change the master source to
cite." When you have selected a source, if you're going to put it on the
clipboard, now is the time to select whether you want Legacy to Prompt for
Detail (lower left of the window). You can either "Load a Clipboard" or
"Save a Clipboard" (see lower, right portion of screen). When you press
Save, the little window comes up. Be sure you have a blank line selected, or
you'll write over a previously saved clipboard. Put in some meaningful
abbreviation of the source. To switch between previously saved clipboard
items, right click on the clipboard arrow.
It was disappointing to see my 10 previously saved clipboard items did not
transfer to V7, but if that's the only bad thing to happen, it's hard to
stay disappointed.
Elizabeth
researching the descendants of William and Sarah (Patterson) Thompson
----- Original Message -----
From: "Margaret E Ullman" <[EMAIL PROTECTED]>
To: <LegacyUserGroup@legacyfamilytree.com>
Sent: Saturday, June 07, 2008 6:39 AM
Subject: [LegacyUG] V7 clipboard use
When I select to arrow to use the clipboard, it goes directly to 'Add
Source
Detail'.
I cannot find where to access the 5 tabs to add 5 different sources.
I feel REALLY dumb. I'm a long time user. I have read the V7 Manual,
checked on-line. Spent about 2 hours this AM.
HELP,
M
Legacy User Group guidelines:
http://www.LegacyFamilyTree.com/Etiquette.asp
Archived messages:
http://www.mail-archive.com/legacyusergroup@legacyfamilytree.com/
Online technical support: http://www.LegacyFamilyTree.com/Help.asp
To unsubscribe: http://www.LegacyFamilyTree.com/LegacyLists.asp
