On 23 June 2011 17:03, R. van Twisk <[email protected]> wrote: > > On Jun 23, 2011, at 2:20 AM, Davinder Kumar wrote: > >> Hello everyone, >> I am using libredwg.Whenever i used convert command like >> ./testSVG input.dwg > output.svg >> it gives following error >> "Segmentation fault" > > > David, what version of dwg is that? If you are talking about version of libredwg, then i don't know the version of libredwg.I have just installed it through git-clone with following command git clone git://git.sv.gnu.org/libredwg.git > I noticed that DWG version 2010 (I believe) > will always segfault. Any solution to this.Tell me where i can get the newest version of libredwg. > > THis was tested with a draftsight export. >OK. > Ries > >> >> >> -- >> http://davinder.in >> Dont hurt the web, use open standards >> > > >
-- http://davinder.in Dont hurt the web, use open standards
