On Jun 23, 2011, at 1:50 PM, Davinder Kumar wrote: > On 23 June 2011 17:03, R. van Twisk <[email protected]> wrote: >> >> On Jun 23, 2011, at 2:20 AM, Davinder Kumar wrote: >> >>> Hello everyone, >>> I am using libredwg.Whenever i used convert command like >>> ./testSVG input.dwg > output.svg >>> it gives following error >>> "Segmentation fault" >> >> >> David, what version of dwg is that? > If you are talking about version of libredwg, then i don't know the > version of libredwg.I have just installed it through git-clone with > following command
No, the version of the DWG, 2010 versions never worked for me. Ries > git clone git://git.sv.gnu.org/libredwg.git >> I noticed that DWG version 2010 (I believe) >> will always segfault. > Any solution to this.Tell me where i can get the newest version of libredwg. >> >> THis was tested with a draftsight export. >> OK. >> Ries >> >>> >>> >>> -- >>> http://davinder.in >>> Dont hurt the web, use open standards >>> >> >> >> > > > > -- > http://davinder.in > Dont hurt the web, use open standards >
