On 24 June 2011 00:35, R. van Twisk <[email protected]> wrote: > > On Jun 23, 2011, at 1:50 PM, Davinder Kumar wrote: > >> On 23 June 2011 17:03, R. van Twisk <[email protected]> wrote: >>> >>> On Jun 23, 2011, at 2:20 AM, Davinder Kumar wrote: >>> >>>> Hello everyone, >>>> I am using libredwg.Whenever i used convert command like >>>> ./testSVG input.dwg > output.svg >>>> it gives following error >>>> "Segmentation fault" >>> >>> >>> David, what version of dwg is that? >> If you are talking about version of libredwg, then i don't know the >> version of libredwg.I have just installed it through git-clone with >> following command > > No, the version of the DWG, 2010 versions never worked for me. You are using which version? > > Ries > >> git clone git://git.sv.gnu.org/libredwg.git >>> I noticed that DWG version 2010 (I believe) >>> will always segfault. >> Any solution to this.Tell me where i can get the newest version of libredwg. >>> >>> THis was tested with a draftsight export. >>> OK. >>> Ries >>> >>>> >>>> >>>> -- >>>> http://davinder.in >>>> Dont hurt the web, use open standards >>>> >>> >>> >>> >> >> >> >> -- >> http://davinder.in >> Dont hurt the web, use open standards >> > > >
-- http://davinder.in Dont hurt the web, use open standards
