I use BuddyAPI, but everytime the programs quit... The resolution is not
restored, even I've used "temp" setting.
And how about to set the refresh rate of monitor. Because everytime I
use basetdisplay...it's only on 60Hz !
> >If it is 600X480 then I want to continue else I would like to change
> >the
> >settings to 600 X 480. When the user clicks the exit button
> I would like
> >to reset the settings to what they were when the movie was
> launched i.e.
> >to the user's screen resolution.
>
> You need an Xtra for this--Buddy API. Check it at www.mods.com.au.
>
[To remove yourself from this list, or to change to digest mode, go to
http://www.penworks.com/LUJ/lingo-l.cgi To post messages to the list,
email [EMAIL PROTECTED] (Problems, email [EMAIL PROTECTED])
Lingo-L is for learning and helping with programming Lingo. Thanks!]