I'd like to run a dynamic routing protocol on my lpar base Red Hat Linux (no z/VM). I want to setup hypersockets and direct some host addresses through the hypersocket interface, everything else out the OSA. I could probably set up static addresses for the host but I'd prefer OSPF. I downloaded Zebra and when I ran the 'configure' script it told me it didn't recognize s390x.
checking for a BSD-compatible install... /usr/bin/install -c checking whether build environment is sane... yes checking for gawk... gawk checking whether make sets $(MAKE)... yes checking build system type... Invalid configuration `s390x-unknown-linux-gnu': machine `s390x-unknown' not recognized configure: error: /bin/sh ./config.sub s390x-unknown-linux-gnu failed Before I start jumping through hoops, anybody run an OSPF daemon on S390 Linux and if so, what is it? Any other suggestions? Thanks Bobby Bauer Center for Information Technology National Institutes of Health Bethesda, MD 20892-5628 301-594-7474 ---------------------------------------------------------------------- For LINUX-390 subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: INFO LINUX-390 or visit http://www.marist.edu/htbin/wlvindex?LINUX-390