On Fri, Mar 30, 2001 at 08:01:01PM +0530, Harishankkar wrote:
> I am getting the same message
> blob>boot
> Uncompressing the kernel.........done.Booting the kernel.
> and here it hangs.
> I have disabled frame buffer and passed the initrd parameters as u said.But
> the
> same kernel works properly with Angel.One thing was that when the kernel was
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
Do NOT use the same kernel. Blob _needs_ CONFIG_ANGELBOOT _disabled_.
> loaded
> the LED D8 was constantly blinking and D9 very little.So earlier also the
> LED's did not blink
I don't remember exactly what the LEDs should do. Looking at the code
my guess is that one of them should blink at a 1 or 2 Hz rate, and the
other one should only turn on when the kernel is not in idle mode.
> But I have not upgraded the kernel I will try it now.But atleast the kernel
> must boot know?
It should.
> Does it have anything to do with the kernel parameter passing?
No. Unless there is something wrong with your blob version:
- You're using a blob version prior to blob-1.0.7 which is known to
pass incorrect architecture numbers to the kernel. Use
blob-1.0.8pre2.
- You didn't compile blob with Assabet support. Use the
--with-board=assabet flag when configuring blob.
Erik
--
J.A.K. (Erik) Mouw, Information and Communication Theory Group, Department
of Electrical Engineering, Faculty of Information Technology and Systems,
Delft University of Technology, PO BOX 5031, 2600 GA Delft, The Netherlands
Phone: +31-15-2783635 Fax: +31-15-2781843 Email: [EMAIL PROTECTED]
WWW: http://www-ict.its.tudelft.nl/~erik/
_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
Please visit the above address for information on this list.
