Hi,
No not at all ,I am sorry that I did not mention that I had disabled
angel when I passed the kernel to blob,I had thought that it did not need
mentioning..What I was trying to say is that in the kernel conf everything
remains the same with just the Angel enabled seems to work perfectly with angel
.. I had compiled blob with board =assabet.Since my blob is jumping
to the code
theKernel(0,25);
Which is for assabet.So I am pretty sure that I had compiled it correctly.
What to do?
Thanx,
hari
On Fri, 30 Mar 2001, you wrote:
> On Fri, Mar 30, 2001 at 08:01:01PM +0530, Harishankkar wrote:
> > I am getting the same message
> > blob>boot
> > Uncompressing the kernel.........done.Booting the kernel.
> > and here it hangs.
> > I have disabled frame buffer and passed the initrd parameters as u said.But
> > the
> > same kernel works properly with Angel.One thing was that when the kernel was
> ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
> Do NOT use the same kernel. Blob _needs_ CONFIG_ANGELBOOT _disabled_.
>
> > loaded
> > the LED D8 was constantly blinking and D9 very little.So earlier also the
> > LED's did not blink
>
> I don't remember exactly what the LEDs should do. Looking at the code
> my guess is that one of them should blink at a 1 or 2 Hz rate, and the
> other one should only turn on when the kernel is not in idle mode.
>
> > But I have not upgraded the kernel I will try it now.But atleast the kernel
> > must boot know?
>
> It should.
>
> > Does it have anything to do with the kernel parameter passing?
>
> No. Unless there is something wrong with your blob version:
>
> - You're using a blob version prior to blob-1.0.7 which is known to
> pass incorrect architecture numbers to the kernel. Use
> blob-1.0.8pre2.
> - You didn't compile blob with Assabet support. Use the
> --with-board=assabet flag when configuring blob.
>
>
> Erik
>
> --
> J.A.K. (Erik) Mouw, Information and Communication Theory Group, Department
> of Electrical Engineering, Faculty of Information Technology and Systems,
> Delft University of Technology, PO BOX 5031, 2600 GA Delft, The Netherlands
> Phone: +31-15-2783635 Fax: +31-15-2781843 Email: [EMAIL PROTECTED]
> WWW: http://www-ict.its.tudelft.nl/~erik/
_______________________________________________
http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
Please visit the above address for information on this list.
