I'm also installing diald 0.99 under RH6. How did you clear the tap0...15
error messages? I'm have the same problem as you described in your first
message:
> I just checked syslog again and I am getting 16 messages about being
unable to locate module tap.
>
> modprobe: can't locate module tap0
> modprobe: can't locate module tap1
> modprobe: can't locate module tap2
> modprobe: can't locate module tap3
> ...
>
> this keeps going on till tap15 at which time it displays the message about
siocsimetric operation not
> supported. Some people mentioned to remove a "metric" option from the
diald.conf but I can't see what
> they mean.
Even with these error messages, diald will work through the chat script and
reach:
Connect: ppp0 <--> /dev/ttyS0
Then I get:
Hangup (SIGHUP)
3 seconds later without fail.
Anyone have any suggestions?
----- Original Message -----
Sent: Friday, October 29, 1999 12:09 AM
Subject: Re: Diald 0.99 under RH6 more info
> I have read through the documentation of the current version and I still
use the old 0.16 version under rh5.1 without any problems.
>
> I have got the tap0 working thanks to someone mentioning the conf.modules
line, but diald is still not bringing up pppd when requests come in.
>
> After trying the debug 0x8 option in the diald.conf file, syslog now
says...
>
> diald[492]: Proxy device established on interface tap0
> diald[492]: Diald initial setup completed
>
>
> After doing a route -n I don't have an sl0 but i do have a tap0.
>
> Any other options to try and get diald to bring my pppd up when required?
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-diald" in
> the body of a message to [EMAIL PROTECTED]
-
To unsubscribe from this list: send the line "unsubscribe linux-diald" in
the body of a message to [EMAIL PROTECTED]
