This watchdog is instantiated in a FPGA and can only be access using a
GPIOs bit-banged bus, called the NBUS by Technologic Systems.
The watchdog is made of only one register, called the feed register.
Writing to this register will re-arm the watchdog for a given time (and
enable it if it was disable). It can be disabled by writing a special
value into it.

Signed-off-by: Sebastien Bourdelin <sebastien.bourde...@savoirfairelinux.com>
---
 .../devicetree/bindings/watchdog/ts4600-wdt.txt    |  16 ++
 arch/arm/boot/dts/imx28-ts4600-common.dtsi         |   5 +
 drivers/watchdog/Kconfig                           |  10 +
 drivers/watchdog/Makefile                          |   1 +
 drivers/watchdog/ts4600_wdt.c                      | 213 +++++++++++++++++++++
 5 files changed, 245 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/watchdog/ts4600-wdt.txt
 create mode 100644 drivers/watchdog/ts4600_wdt.c

diff --git a/Documentation/devicetree/bindings/watchdog/ts4600-wdt.txt 
b/Documentation/devicetree/bindings/watchdog/ts4600-wdt.txt
new file mode 100644
index 0000000..61d620e
--- /dev/null
+++ b/Documentation/devicetree/bindings/watchdog/ts4600-wdt.txt
@@ -0,0 +1,16 @@
+TS-4600 Technologic Systems Watchdog
+
+Required properties:
+- compatible: must be "technologic,ts4600-wdt"
+- reg: offset to the FPGA's watchdog register
+
+Optional property:
+- timeout-sec: contains the watchdog timeout in seconds.
+
+Example:
+
+wdt {
+       compatible = "technologic,ts4600-wdt";
+       reg = <0x2a>;
+       timeout-sec = <10>;
+};
diff --git a/arch/arm/boot/dts/imx28-ts4600-common.dtsi 
b/arch/arm/boot/dts/imx28-ts4600-common.dtsi
index b668933..dd7318c 100644
--- a/arch/arm/boot/dts/imx28-ts4600-common.dtsi
+++ b/arch/arm/boot/dts/imx28-ts4600-common.dtsi
@@ -116,6 +116,11 @@
                strobe-gpios = <&gpio0 25 GPIO_ACTIVE_HIGH>;
                ale-gpios    = <&gpio0 26 GPIO_ACTIVE_HIGH>;
                rdy-gpios    = <&gpio0 21 GPIO_ACTIVE_HIGH>;
+
+               wdt@2a {
+                       compatible = "technologic,ts4600-wdt";
+                       reg = <0x2a>;
+               };
        };
 
 };
diff --git a/drivers/watchdog/Kconfig b/drivers/watchdog/Kconfig
index 3eb58cb..7a8e176 100644
--- a/drivers/watchdog/Kconfig
+++ b/drivers/watchdog/Kconfig
@@ -500,6 +500,16 @@ config NUC900_WATCHDOG
          To compile this driver as a module, choose M here: the
          module will be called nuc900_wdt.
 
+config TS4600_WATCHDOG
+       tristate "TS-4600 Watchdog"
+       depends on HAS_IOMEM && OF
+       depends on SOC_IMX28 || COMPILE_TEST
+       select WATCHDOG_CORE
+       help
+         Technologic Systems TS-4600 has watchdog timer implemented in
+         an external FPGA. Say Y here if you want to support for the
+         watchdog timer on TS-4600 board.
+
 config TS4800_WATCHDOG
        tristate "TS-4800 Watchdog"
        depends on HAS_IOMEM && OF
diff --git a/drivers/watchdog/Makefile b/drivers/watchdog/Makefile
index caa9f4a..d4b4bd2 100644
--- a/drivers/watchdog/Makefile
+++ b/drivers/watchdog/Makefile
@@ -61,6 +61,7 @@ obj-$(CONFIG_RN5T618_WATCHDOG) += rn5t618_wdt.o
 obj-$(CONFIG_COH901327_WATCHDOG) += coh901327_wdt.o
 obj-$(CONFIG_STMP3XXX_RTC_WATCHDOG) += stmp3xxx_rtc_wdt.o
 obj-$(CONFIG_NUC900_WATCHDOG) += nuc900_wdt.o
+obj-$(CONFIG_TS4600_WATCHDOG) += ts4600_wdt.o
 obj-$(CONFIG_TS4800_WATCHDOG) += ts4800_wdt.o
 obj-$(CONFIG_TS72XX_WATCHDOG) += ts72xx_wdt.o
 obj-$(CONFIG_IMX2_WDT) += imx2_wdt.o
diff --git a/drivers/watchdog/ts4600_wdt.c b/drivers/watchdog/ts4600_wdt.c
new file mode 100644
index 0000000..db91b40
--- /dev/null
+++ b/drivers/watchdog/ts4600_wdt.c
@@ -0,0 +1,213 @@
+/*
+ * Watchdog driver for TS-4600 based boards
+ *
+ * Copyright (c) 2016 - Savoir-faire Linux
+ * Author: Sebastien Bourdelin <sebastien.bourde...@savoirfairelinux.com>
+ *
+ * This file is licensed under the terms of the GNU General Public
+ * License version 2. This program is licensed "as is" without any
+ * warranty of any kind, whether express or implied.
+ *
+ * The watchdog on the TS-4600 based boards is in an FPGA and can only be
+ * accessed using a GPIO bit-banged bus called the NBUS by Technologic Systems.
+ * The logic for the watchdog is the same then for the TS-4800 SoM, only the 
way
+ * to access it change, therefore this driver is heavely based on the 
ts4800_wdt
+ * driver from Damien Riegel <damien.rie...@savoirfairelinux.com>.
+ */
+
+#include <linux/kernel.h>
+#include <linux/module.h>
+#include <linux/of.h>
+#include <linux/platform_device.h>
+#include <linux/ts-nbus.h>
+#include <linux/watchdog.h>
+
+static bool nowayout = WATCHDOG_NOWAYOUT;
+module_param(nowayout, bool, 0);
+MODULE_PARM_DESC(nowayout,
+       "Watchdog cannot be stopped once started (default="
+       __MODULE_STRING(WATCHDOG_NOWAYOUT) ")");
+
+/* possible feed values */
+#define TS4600_WDT_FEED_2S       0x1
+#define TS4600_WDT_FEED_10S      0x2
+#define TS4600_WDT_DISABLE       0x3
+
+struct ts4600_wdt {
+       struct watchdog_device  wdd;
+       u32                     feed_offset;
+       u32                     feed_val;
+};
+
+/*
+ * TS-4600 supports the following timeout values:
+ *
+ *   value desc
+ *   ---------------------
+ *     0    feed for 338ms
+ *     1    feed for 2.706s
+ *     2    feed for 10.824s
+ *     3    disable watchdog
+ *
+ * Keep the regmap/timeout map ordered by timeout
+ */
+static const struct {
+       const int timeout;
+       const int regval;
+} ts4600_wdt_map[] = {
+       { 2,  TS4600_WDT_FEED_2S },
+       { 10, TS4600_WDT_FEED_10S },
+};
+
+#define MAX_TIMEOUT_INDEX       (ARRAY_SIZE(ts4600_wdt_map) - 1)
+
+static void ts4600_write_feed(struct ts4600_wdt *wdt, u32 val)
+{
+       ts_nbus_write(wdt->feed_offset, val);
+}
+
+static int ts4600_wdt_start(struct watchdog_device *wdd)
+{
+       struct ts4600_wdt *wdt = watchdog_get_drvdata(wdd);
+
+       ts4600_write_feed(wdt, wdt->feed_val);
+
+       return 0;
+}
+
+static int ts4600_wdt_stop(struct watchdog_device *wdd)
+{
+       struct ts4600_wdt *wdt = watchdog_get_drvdata(wdd);
+
+       ts4600_write_feed(wdt, TS4600_WDT_DISABLE);
+       return 0;
+}
+
+static int ts4600_wdt_set_timeout(struct watchdog_device *wdd,
+                                 unsigned int timeout)
+{
+       struct ts4600_wdt *wdt = watchdog_get_drvdata(wdd);
+       int i;
+
+       for (i = 0; i < MAX_TIMEOUT_INDEX; i++) {
+               if (ts4600_wdt_map[i].timeout >= timeout)
+                       break;
+       }
+
+       wdd->timeout = ts4600_wdt_map[i].timeout;
+       wdt->feed_val = ts4600_wdt_map[i].regval;
+
+       return 0;
+}
+
+static const struct watchdog_ops ts4600_wdt_ops = {
+       .owner = THIS_MODULE,
+       .start = ts4600_wdt_start,
+       .stop = ts4600_wdt_stop,
+       .set_timeout = ts4600_wdt_set_timeout,
+};
+
+static const struct watchdog_info ts4600_wdt_info = {
+       .options = WDIOF_SETTIMEOUT | WDIOF_MAGICCLOSE | WDIOF_KEEPALIVEPING,
+       .identity = "TS-4600 Watchdog",
+};
+
+static int ts4600_wdt_probe(struct platform_device *pdev)
+{
+       struct device_node *np = pdev->dev.of_node;
+       struct watchdog_device *wdd;
+       struct ts4600_wdt *wdt;
+       u32 reg;
+       int ret;
+
+       ret = of_property_read_u32(np, "reg", &reg);
+       if (ret < 0) {
+               dev_err(&pdev->dev, "missing reg property\n");
+               return ret;
+       }
+
+       /* check for the NBUS state and defer the probing if it is not ready */
+       if (!ts_nbus_is_ready())
+               return -EPROBE_DEFER;
+
+       /* allocate memory for watchdog struct */
+       wdt = devm_kzalloc(&pdev->dev, sizeof(*wdt), GFP_KERNEL);
+       if (!wdt)
+               return -ENOMEM;
+
+       /* set offset to know where to write */
+       wdt->feed_offset = reg;
+
+       /* Initialize struct watchdog_device */
+       wdd = &wdt->wdd;
+       wdd->parent = &pdev->dev;
+       wdd->info = &ts4600_wdt_info;
+       wdd->ops = &ts4600_wdt_ops;
+       wdd->min_timeout = ts4600_wdt_map[0].timeout;
+       wdd->max_timeout = ts4600_wdt_map[MAX_TIMEOUT_INDEX].timeout;
+
+       watchdog_set_drvdata(wdd, wdt);
+       watchdog_set_nowayout(wdd, nowayout);
+       watchdog_init_timeout(wdd, 0, &pdev->dev);
+
+       /*
+        * As this watchdog supports only a few values, ts4600_wdt_set_timeout
+        * must be called to initialize timeout and feed_val with valid values.
+        * Default to maximum timeout if none, or an invalid one, is provided in
+        * device tree.
+        */
+       if (!wdd->timeout)
+               wdd->timeout = wdd->max_timeout;
+       ts4600_wdt_set_timeout(wdd, wdd->timeout);
+
+       /*
+        * The feed register is write-only, so it is not possible to determine
+        * watchdog's state. Disable it to be in a known state.
+        */
+       ts4600_wdt_stop(wdd);
+
+       ret = watchdog_register_device(wdd);
+       if (ret) {
+               dev_err(&pdev->dev,
+                       "failed to register watchdog device\n");
+               return ret;
+       }
+
+       platform_set_drvdata(pdev, wdt);
+
+       dev_info(&pdev->dev,
+                "initialized (timeout = %d sec, nowayout = %d)\n",
+                wdd->timeout, nowayout);
+
+       return 0;
+}
+
+static int ts4600_wdt_remove(struct platform_device *pdev)
+{
+       struct ts4600_wdt *wdt = platform_get_drvdata(pdev);
+
+       watchdog_unregister_device(&wdt->wdd);
+
+       return 0;
+}
+
+static const struct of_device_id ts4600_wdt_of_match[] = {
+       { .compatible = "technologic,ts4600-wdt", },
+       { },
+};
+MODULE_DEVICE_TABLE(of, ts4600_wdt_of_match);
+
+static struct platform_driver ts4600_wdt_driver = {
+       .probe          = ts4600_wdt_probe,
+       .remove         = ts4600_wdt_remove,
+       .driver         = {
+               .name   = "ts4600_wdt",
+               .of_match_table = ts4600_wdt_of_match,
+       },
+};
+
+module_platform_driver(ts4600_wdt_driver);
+
+MODULE_AUTHOR("Sebastien Bourdelin 
<sebastien.bourde...@savoirfairelinux.com>");
+MODULE_LICENSE("GPL v2");
+MODULE_ALIAS("platform:ts4600_wdt");
-- 
2.10.2

Reply via email to