Use the correct interrupt flags and change the 'interrupt-parent', 'interrupts' property pairs to 'interrupts-extended'.
Signed-off-by: Lothar Waßmann <[email protected]> --- arch/arm/boot/dts/imx53-tx53-x03x.dts | 6 ++---- arch/arm/boot/dts/imx53-tx53.dtsi | 6 ++---- 2 files changed, 4 insertions(+), 8 deletions(-) diff --git a/arch/arm/boot/dts/imx53-tx53-x03x.dts b/arch/arm/boot/dts/imx53-tx53-x03x.dts index aa9ae84..632a097 100644 --- a/arch/arm/boot/dts/imx53-tx53-x03x.dts +++ b/arch/arm/boot/dts/imx53-tx53-x03x.dts @@ -242,8 +242,7 @@ reg = <0x38>; pinctrl-names = "default"; pinctrl-0 = <&pinctrl_edt_ft5x06_1>; - interrupt-parent = <&gpio6>; - interrupts = <15 IRQ_TYPE_EDGE_FALLING>; + interrupts-extended = <&gpio6 15 IRQ_TYPE_EDGE_FALLING>; reset-gpios = <&gpio2 22 GPIO_ACTIVE_LOW>; wake-gpios = <&gpio2 21 GPIO_ACTIVE_HIGH>; }; @@ -253,8 +252,7 @@ reg = <0x48>; pinctrl-names = "default"; pinctrl-0 = <&pinctrl_tsc2007>; - interrupt-parent = <&gpio3>; - interrupts = <26 0>; + interrupts-extended = <&gpio3 26 IRQ_TYPE_EDGE_FALLING>; gpios = <&gpio3 26 GPIO_ACTIVE_LOW>; ti,x-plate-ohms = <660>; wakeup-source; diff --git a/arch/arm/boot/dts/imx53-tx53.dtsi b/arch/arm/boot/dts/imx53-tx53.dtsi index 8e10c47..76e7186 100644 --- a/arch/arm/boot/dts/imx53-tx53.dtsi +++ b/arch/arm/boot/dts/imx53-tx53.dtsi @@ -226,8 +226,7 @@ status = "okay"; phy0: ethernet-phy@0 { - interrupt-parent = <&gpio2>; - interrupts = <4>; + interrupts-extended = <&gpio2 4 IRQ_TYPE_EDGE_FALLING>; device_type = "ethernet-phy"; }; }; @@ -246,8 +245,7 @@ reg = <0x68>; pinctrl-names = "default"; pinctrl-0 = <&pinctrl_ds1339>; - interrupt-parent = <&gpio4>; - interrupts = <20 0>; + interrupts-extended = <&gpio4 20 IRQ_TYPE_EDGE_FALLING>; trickle-resistor-ohms = <250>; trickle-diode-disable; }; -- 2.1.4
