This patch exports the host capabilities to debugfs

This idea of sharing host capabilities over debugfs
came up from Abbas Raza <abbas_r...@mentor.com>
Earlier discussions:
https://lkml.org/lkml/2018/3/5/357
https://www.spinics.net/lists/linux-mmc/msg48219.html

Signed-off-by: Harish Jenny K N <harish_kand...@mentor.com>
---

Changes in v9
- More code cleanup as suggested by Andy Shevchenko.

Changes in v8
- Changes to use for_each_set_bit as suggested by Andy Shevchenko.

Changes in v7
- Moved additional capabilities also to caps file as mentioned by Ulf Hansson
- compacting the code with macros

Changes in v6:
- Used DEFINE_SHOW_ATTRIBUTE

Changes in v5:
- Added parser logic in kernel by using debugfs_create_file  for caps and caps2 
instead of debugfs_create_x32
- Changed Author

Changes in v4:
- Moved the creation of nodes to mmc_add_host_debugfs
- Exported caps2
- Renamed host_caps to caps

Changes in v3:
- Removed typecasting of &host->caps to (u32 *)

Changes in v2:
- Changed Author

 drivers/mmc/core/debugfs.c | 107 +++++++++++++++++++++++++++++++++++++++++++++
 1 file changed, 107 insertions(+)

diff --git a/drivers/mmc/core/debugfs.c b/drivers/mmc/core/debugfs.c
index c51e0c0..e19305a 100644
--- a/drivers/mmc/core/debugfs.c
+++ b/drivers/mmc/core/debugfs.c
@@ -225,6 +225,110 @@ static int mmc_clock_opt_set(void *data, u64 val)
 DEFINE_SIMPLE_ATTRIBUTE(mmc_clock_fops, mmc_clock_opt_get, mmc_clock_opt_set,
        "%llu\n");

+/*
+ * mmc_host_capabilities - MMC host capabilities
+ *
+ * This must be in sync with caps definitions in the mmc/host.h
+ */
+static const char * const mmc_host_capabilities[] = {
+       "4-bit transfers allowed",
+       "Supports MMC high-speed timing",
+       "Supports SD high-speed timing",
+       "Can signal pending SDIO IRQs",
+       "Talks only SPI protocols",
+       "Needs polling for card-detection",
+       "8 bit transfers allowed",
+       "Suspends (e)MMC/SD at idle",
+       "Nonremovable",
+       "Waits while card is busy",
+       "Allows erase/trim commands",
+       "Supports DDR mode at 3.3V",
+       "Supports DDR mode at 1.8V",
+       "Supports DDR mode at 1.2V",
+       "Can power off after boot",
+       "CMD14/CMD19 bus width ok",
+       "Supports UHS SDR12 mode",
+       "Supports UHS SDR25 mode",
+       "Supports UHS SDR50 mode",
+       "Supports UHS SDR104 mode",
+       "Supports UHS DDR50 mode",
+       "Unknown (bit 21)",
+       "Unknown (bit 22)",
+       "Supports Driver Type A",
+       "Supports Driver Type C",
+       "Supports Driver Type D",
+       "Unknown (bit 26)",
+       "RW reqs can be completed within mmc_request_done()",
+       "Supports Enable card detect wake",
+       "Can send commands during data transfer",
+       "CMD23 supported",
+       "Supports Hardware reset"
+};
+
+/*
+ * mmc_host_capabilities2 - MMC host additional capabilities
+ *
+ * This must be in sync with caps2 definitions in the mmc/host.h
+ */
+static const char * const mmc_host_capabilities2[] = {
+       "No access to Boot partition",
+       "Unknown (bit 1)",
+       "Can do full power cycle",
+       "Unknown (bit 3)",
+       "Unknown (bit 4)",
+       "Supports HS200 1.8V SDR",
+       "Supports HS200 1.2V SDR",
+       "Unknown (bit 7)",
+       "Unknown (bit 8)",
+       "Unknown (bit 9)",
+       "Card-detect signal active high",
+       "Write-protect signal active high",
+       "Unknown (bit 12)",
+       "Unknown (bit 13)",
+       "Can do complete power cycle of the card",
+       "Supports HS400 1.8V",
+       "Support HS400 1.2V",
+       "SDIO IRQ - Nothread",
+       "No physical write protect pin, assume always read-write",
+       "Do not send SDIO commands during initialization",
+       "Supports enhanced strobe",
+       "Do not send SD commands during initialization",
+       "Do not send (e)MMC commands during initialization",
+       "Has eMMC command queue engine",
+       "CQE can issue a direct command",
+       "Unknown (bit 25)",
+       "Unknown (bit 26)",
+       "Unknown (bit 27)",
+       "Unknown (bit 28)",
+       "Unknown (bit 29)",
+       "Unknown (bit 30)",
+       "Unknown (bit 31)"
+};
+
+static int mmc_caps_show(struct seq_file *s, void *unused)
+{
+       struct mmc_host *host = s->private;
+       unsigned long caps = host->caps;
+       unsigned long caps2 = host->caps2;
+       int bit;
+
+       seq_puts(s, "MMC Host capabilities are:\n");
+       seq_puts(s, "=============================================\n");
+
+       for_each_set_bit(bit, (const unsigned long *)&caps, BITS_PER_LONG)
+               seq_printf(s, "%s\n", mmc_host_capabilities[bit]);
+
+       seq_puts(s, "=============================================\n");
+       seq_puts(s, "MMC Host additional capabilities are:\n");
+       seq_puts(s, "=============================================\n");
+
+       for_each_set_bit(bit, (const unsigned long *)&caps2, BITS_PER_LONG)
+               seq_printf(s, "%s\n", mmc_host_capabilities2[bit]);
+
+       return 0;
+}
+DEFINE_SHOW_ATTRIBUTE(mmc_caps);
+
 void mmc_add_host_debugfs(struct mmc_host *host)
 {
        struct dentry *root;
@@ -243,6 +347,9 @@ void mmc_add_host_debugfs(struct mmc_host *host)
        if (!debugfs_create_file("ios", S_IRUSR, root, host, &mmc_ios_fops))
                goto err_node;

+       if (!debugfs_create_file("caps", S_IRUSR, root, host, &mmc_caps_fops))
+               goto err_node;
+
        if (!debugfs_create_file("clock", S_IRUSR | S_IWUSR, root, host,
                        &mmc_clock_fops))
                goto err_node;
--
1.9.1

Reply via email to