On Mon, Jun 04, 2018 at 04:16:33PM +0530, Taniya Das wrote:
> Add QCOM cpufreq firmware device bindings for Qualcomm Technology Inc's
> SoCs. This is required for managing the cpu frequency transitions which are
> controlled by firmware.
>
> Signed-off-by: Taniya Das <t...@codeaurora.org>
> ---
> .../bindings/cpufreq/cpufreq-qcom-fw.txt | 173
> +++++++++++++++++++++
> 1 file changed, 173 insertions(+)
> create mode 100644
> Documentation/devicetree/bindings/cpufreq/cpufreq-qcom-fw.txt
>
> diff --git a/Documentation/devicetree/bindings/cpufreq/cpufreq-qcom-fw.txt
> b/Documentation/devicetree/bindings/cpufreq/cpufreq-qcom-fw.txt
> new file mode 100644
> index 0000000..e3087ec
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/cpufreq/cpufreq-qcom-fw.txt
> @@ -0,0 +1,173 @@
> +Qualcomm Technologies, Inc. CPUFREQ Bindings
> +
> +CPUFREQ FW is a hardware engine used by some Qualcomm Technologies, Inc.
> (QTI)
> +SoCs to manage frequency in hardware. It is capable of controlling frequency
> +for multiple clusters.
> +
> +Properties:
> +- compatible
> + Usage: required
> + Value type: <string>
> + Definition: must be "qcom,cpufreq-fw".
> +
> +* Property qcom,freq-domain
> +Devices supporting freq-domain must set their "qcom,freq-domain" property
> with
> +phandle to a freq_domain_table in their DT node.
> +
> +* Frequency Domain Table Node
> +
> +This describes the frequency domain belonging to a device.
> +This node can have following properties:
> +
> +- reg
> + Usage: required
> + Value type: <prop-encoded-array>
> + Definition: Addresses and sizes for the memory of the perf
> + , lut and enable bases.
> + perf - indicates the base address for the desired
> + performance state to be set.
> + lut - indicates the look up table base address for the
> + cpufreq driver to read frequencies.
> + enable - indicates the enable register for firmware.
> +- reg-names
> + Usage: required
> + Value type: <stringlist>
> + Definition: Address names. Must be "perf", "lut", "enable".
> + Must be specified in the same order as the reg property.
> +
[...]
> +
> + qcom,cpufreq-fw {
> + compatible = "qcom,cpufreq-fw";
> +
> + #address-cells = <1>;
> + #size-cells = <1>;
> +
> + freq_domain_table0 : freq_table0 {
> + reg = <0x17d43920 0x4>, <0x17d43110 0x500>,
> + <0x17d41000 0x4>;
Are "perf", "lut", "enable" registers part of single IP block / share memory ?
I am just trying to understand the reason for separate entries in this fashion
as part of DT register property. I am wondering if there will be multiple
entries that fall with the page size.
--
Regards,
Sudeep
