[PATCH v2 14/17] thermal: ti-soc-thermal: enable+check sensor after its setup is finished

[Bartlomiej Zolnierkiewicz]

Enable sensor after setting sensor data and check sensor after
writing update interval.

Cc: Eduardo Valentin <edubez...@gmail.com>
Cc: Keerthy <j-keer...@ti.com>
Signed-off-by: Bartlomiej Zolnierkiewicz <b.zolnier...@samsung.com>
---
 drivers/thermal/ti-soc-thermal/ti-thermal-common.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/thermal/ti-soc-thermal/ti-thermal-common.c 
b/drivers/thermal/ti-soc-thermal/ti-thermal-common.c
index aa15719..4675d96 100644
--- a/drivers/thermal/ti-soc-thermal/ti-thermal-common.c
+++ b/drivers/thermal/ti-soc-thermal/ti-thermal-common.c
@@ -197,13 +197,15 @@ int ti_thermal_expose_sensor(struct ti_bandgap *bgp, int 
id,
                return PTR_ERR(data->ti_thermal);
        }
 
+       ti_bandgap_set_sensor_data(bgp, id, data);
+
        thermal_zone_set_mode(data->ti_thermal, THERMAL_DEVICE_ENABLED);
-       thermal_zone_device_check(data->ti_thermal);
 
-       ti_bandgap_set_sensor_data(bgp, id, data);
        ti_bandgap_write_update_interval(bgp, data->sensor_id,
                                        data->ti_thermal->polling_delay);
 
+       thermal_zone_device_check(data->ti_thermal);
+
        return 0;
 }
 
-- 
1.9.1