Hi, Alexandre, On 12/10/2018 11:35 PM, Alexandre Belloni wrote: > Hi, > > On 10/12/2018 17:15:29+0000, [email protected] wrote: >> From: Cyrille Pitchen <[email protected]> >> >> This patch configures the QSPI0 controller pin muxing and declares >> a jedec,spi-nor memory. >> >> sama5d2 Xplained RevB and RevC use the Macronix MX25L25673G flash >> memory which advertises a maximum frequency of 80MHz for Quad IO >> Fast Read. Set the spi-max-frequency to 80MHz knowing that actually >> the QSPI drver will set the SPI bus clock to 166MHz / 3 = 55.3MHz. >> >> Signed-off-by: Cyrille Pitchen <[email protected]> >> [[email protected]: >> - drop partitions, >> - add spi-rx/tx-bus-width >> - change spi-max-frequency to match the 80MHz limit advertised by >> MX25L25673G for Quad IO Fast Read, >> - reword commit message and subject.] >> Signed-off-by: Tudor Ambarus <[email protected]> >> --- >> arch/arm/boot/dts/at91-sama5d2_xplained.dts | 31 >> +++++++++++++++++++++++++++++ >> 1 file changed, 31 insertions(+) >> >> diff --git a/arch/arm/boot/dts/at91-sama5d2_xplained.dts >> b/arch/arm/boot/dts/at91-sama5d2_xplained.dts >> index 518e2b095ccf..171bc82cfbbf 100644 >> --- a/arch/arm/boot/dts/at91-sama5d2_xplained.dts >> +++ b/arch/arm/boot/dts/at91-sama5d2_xplained.dts >> @@ -108,6 +108,21 @@ >> }; >> >> apb { >> + qspi0: spi@f0020000 { >> + pinctrl-names = "default"; >> + pinctrl-0 = <&pinctrl_qspi0_default>; >> + /* status = "okay"; */ /* conflict with sdmmc1 >> */ > > Isn't that conflicting then because I think the default is okay. qspi0 is disabled in sama5d2.dtsi.
Thanks, ta
