Hi,
On Mon, Jan 21, 2019 at 9:52 PM Bjorn Andersson
<[email protected]> wrote:
>
> Add the ADSP and CDSP nodes for PAS-based remoteproc, supporting booting
> these cores on e.g. the MTP, and enable the same for the MTP.
>
> Signed-off-by: Bjorn Andersson <[email protected]>
> ---
>
> Changes since v2:
> - New patch
>
> arch/arm64/boot/dts/qcom/sdm845-mtp.dts | 8 ++++
> arch/arm64/boot/dts/qcom/sdm845.dtsi | 58 +++++++++++++++++++++++++
> 2 files changed, 66 insertions(+)
It's a bit of a nit of mine that if it's not totally obvious what
acronyms mean that they should be spelled out in places that use them.
In this case I believe ADSP is the Audio DSP. Is CDSP the Camera DSP? ...or ?
> + adsp_pas: remoteproc-adsp {
> + compatible = "qcom,sdm845-adsp-pas";
> +
> + interrupts-extended = <&intc GIC_SPI 162
> IRQ_TYPE_EDGE_RISING>,
> + <&adsp_smp2p_in 0 IRQ_TYPE_EDGE_RISING>,
> + <&adsp_smp2p_in 1 IRQ_TYPE_EDGE_RISING>,
> + <&adsp_smp2p_in 2 IRQ_TYPE_EDGE_RISING>,
> + <&adsp_smp2p_in 3 IRQ_TYPE_EDGE_RISING>;
> + interrupt-names = "wdog", "fatal", "ready",
> + "handover", "stop-ack";
> +
> + clocks = <&xo_board>;
> + clock-names = "xo";
I've found that nearly all the places that refer to xo_board are wrong
and should actually point to '<&rpmhcc RPMH_CXO_CLK>'. Maybe yours
should too?
-Doug
