On 3/17/21 8:21 PM, Jack Yu wrote:
This patch adds jsl_rt5682_rt1015p which supports the RT5682 headset
codec and ALC1015Q-VB speaker amplifier combination on JasperLake
platform.
This driver also supports ALC1015Q-CG if running in auto-mode.
Following table shows the audio interface support of the two
amplifiers.
| ALC1015Q-CG | ALC1015Q-VB
=====================================
I2C | Yes | No
Auto-mode | 48K, 64fs | 16k, 32fs
| 48k, 32fs
| 48k, 64fs
Signed-off-by: Brent Lu <brent...@intel.com>
The code is looks fine, but Jack Yu added a separate patch that makes
RTL1019 equivalent to RTL1015, so should this patch also handle the
RTL1019 case?
For rt1019 non-i2c mode (auto mode), it uses the sdb pin to enable amp, the
same as rt1015 non-i2c mode,
therefore we propose rt1019(auto mode) to use rt1015p instead of adding a new
driver for it.
ok, that's fine.
Acked-by: Pierre-Louis Bossart <pierre-louis.boss...@linux.intel.com>
