Add temp-alarm and GPIO support for pm8350c.
Signed-off-by: satya priya <[email protected]>
---
arch/arm64/boot/dts/qcom/pm8350c.dtsi | 53 +++++++++++++++++++++++++++++++++++
1 file changed, 53 insertions(+)
create mode 100644 arch/arm64/boot/dts/qcom/pm8350c.dtsi
diff --git a/arch/arm64/boot/dts/qcom/pm8350c.dtsi
b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
new file mode 100644
index 0000000..f2538b3
--- /dev/null
+++ b/arch/arm64/boot/dts/qcom/pm8350c.dtsi
@@ -0,0 +1,53 @@
+// SPDX-License-Identifier: BSD-3-Clause
+// Copyright (c) 2021, The Linux Foundation. All rights reserved.
+
+#include <dt-bindings/interrupt-controller/irq.h>
+#include <dt-bindings/spmi/spmi.h>
+
+&spmi_bus {
+ pm8350c: pmic@2 {
+ compatible = "qcom,pm8350c", "qcom,spmi-pmic";
+ reg = <0x2 SPMI_USID>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ pm8350c_temp_alarm: temp-alarm@a00 {
+ compatible = "qcom,spmi-temp-alarm";
+ reg = <0xa00>;
+ interrupts = <0x2 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
+ #thermal-sensor-cells = <0>;
+ };
+
+ pm8350c_gpios: gpios@8800 {
+ compatible = "qcom,pm8350c-gpio", "qcom,spmi-gpio";
+ reg = <0x8800>;
+ gpio-controller;
+ gpio-ranges = <&pm8350c_gpios 0 0 9>;
+ #gpio-cells = <2>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ };
+ };
+};
+
+&thermal_zones {
+ pm8350c_thermal: pm8350c-thermal {
+ polling-delay-passive = <100>;
+ polling-delay = <0>;
+ thermal-sensors = <&pm8350c_temp_alarm>;
+
+ trips {
+ pm8350c_trip0: trip0 {
+ temperature = <95000>;
+ hysteresis = <0>;
+ type = "passive";
+ };
+
+ pm8350c_trip1: trip1 {
+ temperature = <115000>;
+ hysteresis = <0>;
+ type = "critical";
+ };
+ };
+ };
+};
--
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member
of Code Aurora Forum, hosted by The Linux Foundation
