smertz wrote:
Ray Olszewski wrote:
At 02:35 PM 4/7/2005 -0600, smertz wrote:
I have a new computer I installed Linux on Red Hat Enterprise Linux
ES release 4 (Nahant), it has one of those all-in-one card readers on
it. I have made mountpoints as root as follows for my thumb, Compact
flash and secure digital drive.
mkdir /mnt/thumb
mkdir /mnt/cf
mkdir /mnt/sd
Now when I tried to mount the Thumb (USB) drive I got an error #
mount /dev/sda2 /mnt/thumb
mount: /dev/sda2 already mounted or /mnt/thumb busy.
So what have I done wrong? I'm thinking sda2 is wrong, but don't know
why?
df -h shows the following
[root localhost mnt]# df -h
Filesystem Size Used Avail Use% Mounted on
/dev/mapper/VolGroup00-LogVol00
183G 2.9G 171G 2% /
/dev/sda1 99M 19M 76M 20% /boot
none 247M 0 247M 0% /dev/shm
[root localhost mnt]#
You don't tell us anything about your hardware, so any responses
really are largely guesses. From the df output you show above, I'd
infer that sda is a physical hard disk of some type.
The card reader, then, is more likely sdb than sda, so I'd be trying
sdb1 or sdb2 for the thumbdrive. Each possible device will have a
different sdb* value, and figuring oout which is which is largely
guesswork ... unless you're lucky enough to have a kernel with the
sort of USB support for hotplugging that tells you where things
connect to (in my experience, output to the console.
See what "more /proc/scsi/scsi" tells you about what the kernel
*thinks* is connected. Please include this info if you need to post a
followup.
-
To unsubscribe from this list: send the line "unsubscribe
linux-newbie" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.linux-learn.org/faqs
This is the last few lines from dmesg. Based on this how would one
mount if I have made the mountpoint of /mnt/thumb
SCSI device sdc: 256000 512-byte hdwr sectors (131 MB)
sdc: Write Protect is off
sdc: Mode Sense: 02 00 00 00
sdc: assuming drive cache: write through
sdc: sdc1
Attached scsi removable disk sdc at scsi3, channel 0, id 0, lun 0
USB Mass Storage device found at 4
mount /dev/sdc1 /mnt/thumb
HTH, Chuck
Red Hat Enterprise Linux ES release 4 (Nahant)
$ cat /proc/scsi/scsi
Attached devices:
Host: scsi0 Channel: 00 Id: 00 Lun: 00
Vendor: ATA Model: ST3200822AS Rev: 3.02
Type: Direct-Access ANSI SCSI revision: 05
Host: scsi2 Channel: 00 Id: 00 Lun: 00
Vendor: eM Model: Bay Reader Rev: 1.00
Type: Direct-Access ANSI SCSI revision: 02
Thanks
-
To unsubscribe from this list: send the line "unsubscribe linux-newbie" in
the body of a message to [EMAIL PROTECTED]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.linux-learn.org/faqs
